RE: [PATCH v2 3/4] iommu/vt-d: Report page request faults for guest SVA

[Tian, Kevin]

> From: Tian, Kevin
> Sent: Monday, July 6, 2020 9:30 AM
> 
> > From: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx>
> > Sent: Monday, July 6, 2020 8:26 AM
> >
> > A pasid might be bound to a page table from a VM guest via the iommu
> > ops.sva_bind_gpasid. In this case, when a DMA page fault is detected
> > on the physical IOMMU, we need to inject the page fault request into
> > the guest. After the guest completes handling the page fault, a page
> > response need to be sent back via the iommu ops.page_response().
> >
> > This adds support to report a page request fault. Any external module
> > which is interested in handling this fault should regiester a notifier
> > callback.
> 
> be specific on which notifier to be registered...
> 
> >
> > Co-developed-by: Jacob Pan <jacob.jun.pan@xxxxxxxxxxxxxxx>
> > Signed-off-by: Jacob Pan <jacob.jun.pan@xxxxxxxxxxxxxxx>
> > Co-developed-by: Liu Yi L <yi.l.liu@xxxxxxxxx>
> > Signed-off-by: Liu Yi L <yi.l.liu@xxxxxxxxx>
> > Signed-off-by: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx>
> > ---
> >  drivers/iommu/intel/svm.c | 99 ++++++++++++++++++++++++++++++++-----
> --
> >  1 file changed, 81 insertions(+), 18 deletions(-)
> >
> > diff --git a/drivers/iommu/intel/svm.c b/drivers/iommu/intel/svm.c
> > index c23167877b2b..08c58c2b1a06 100644
> > --- a/drivers/iommu/intel/svm.c
> > +++ b/drivers/iommu/intel/svm.c
> > @@ -815,6 +815,57 @@ static void intel_svm_drain_prq(struct device *dev,
> > int pasid)
> >  	}
> >  }
> >
> > +static int prq_to_iommu_prot(struct page_req_dsc *req)
> > +{
> > +	int prot = 0;
> > +
> > +	if (req->rd_req)
> > +		prot |= IOMMU_FAULT_PERM_READ;
> > +	if (req->wr_req)
> > +		prot |= IOMMU_FAULT_PERM_WRITE;
> > +	if (req->exe_req)
> > +		prot |= IOMMU_FAULT_PERM_EXEC;
> > +	if (req->pm_req)
> > +		prot |= IOMMU_FAULT_PERM_PRIV;
> > +
> > +	return prot;
> > +}
> > +
> > +static int
> > +intel_svm_prq_report(struct device *dev, struct page_req_dsc *desc)
> > +{
> > +	struct iommu_fault_event event;
> > +	u8 bus, devfn;
> > +
> > +	memset(&event, 0, sizeof(struct iommu_fault_event));
> > +	bus = PCI_BUS_NUM(desc->rid);
> > +	devfn = desc->rid & 0xff;
> 
> not required.
> 
> > +
> > +	/* Fill in event data for device specific processing */
> > +	event.fault.type = IOMMU_FAULT_PAGE_REQ;
> > +	event.fault.prm.addr = desc->addr;
> > +	event.fault.prm.pasid = desc->pasid;
> > +	event.fault.prm.grpid = desc->prg_index;
> > +	event.fault.prm.perm = prq_to_iommu_prot(desc);
> > +
> > +	/*
> > +	 * Set last page in group bit if private data is present,
> > +	 * page response is required as it does for LPIG.
> > +	 */
> 
> move to priv_data_present check?
> 
> > +	if (desc->lpig)
> > +		event.fault.prm.flags |=
> > IOMMU_FAULT_PAGE_REQUEST_LAST_PAGE;
> > +	if (desc->pasid_present)
> > +		event.fault.prm.flags |=
> > IOMMU_FAULT_PAGE_REQUEST_PASID_VALID;
> > +	if (desc->priv_data_present) {
> > +		event.fault.prm.flags |=
> > IOMMU_FAULT_PAGE_REQUEST_LAST_PAGE;

btw earlier comment is more about the behavior of the fault
handler (e.g. the guest), but not about why we need convert
to last_page prm flag. Let's make it clear that doing so is 
because iommu_report_device_fault doesn't understand this
vt-d specific requirement thus we set last_page as a workaround.

Thanks
Kevin

> > +		event.fault.prm.flags |=
> > IOMMU_FAULT_PAGE_REQUEST_PRIV_DATA;
> > +		memcpy(event.fault.prm.private_data, desc->priv_data,
> > +		       sizeof(desc->priv_data));
> > +	}
> > +
> > +	return iommu_report_device_fault(dev, &event);
> > +}
> > +
> >  static irqreturn_t prq_event_thread(int irq, void *d)
> >  {
> >  	struct intel_iommu *iommu = d;
> > @@ -828,7 +879,7 @@ static irqreturn_t prq_event_thread(int irq, void *d)
> >  	tail = dmar_readq(iommu->reg + DMAR_PQT_REG) &
> > PRQ_RING_MASK;
> >  	head = dmar_readq(iommu->reg + DMAR_PQH_REG) &
> > PRQ_RING_MASK;
> >  	while (head != tail) {
> > -		struct intel_svm_dev *sdev;
> > +		struct intel_svm_dev *sdev = NULL;
> 
> move to outside of the loop, otherwise later check always hit "if (!sdev)"
> 
> >  		struct vm_area_struct *vma;
> >  		struct page_req_dsc *req;
> >  		struct qi_desc resp;
> > @@ -864,6 +915,20 @@ static irqreturn_t prq_event_thread(int irq, void
> *d)
> >  			}
> >  		}
> >
> > +		if (!sdev || sdev->sid != req->rid) {
> > +			struct intel_svm_dev *t;
> > +
> > +			sdev = NULL;
> > +			rcu_read_lock();
> > +			list_for_each_entry_rcu(t, &svm->devs, list) {
> > +				if (t->sid == req->rid) {
> > +					sdev = t;
> > +					break;
> > +				}
> > +			}
> > +			rcu_read_unlock();
> > +		}
> > +
> >  		result = QI_RESP_INVALID;
> >  		/* Since we're using init_mm.pgd directly, we should never
> > take
> >  		 * any faults on kernel addresses. */
> > @@ -874,6 +939,17 @@ static irqreturn_t prq_event_thread(int irq, void
> *d)
> >  		if (!is_canonical_address(address))
> >  			goto bad_req;
> >
> > +		/*
> > +		 * If prq is to be handled outside iommu driver via receiver of
> > +		 * the fault notifiers, we skip the page response here.
> > +		 */
> > +		if (svm->flags & SVM_FLAG_GUEST_MODE) {
> > +			if (sdev && !intel_svm_prq_report(sdev->dev, req))
> > +				goto prq_advance;
> > +			else
> > +				goto bad_req;
> > +		}
> > +
> >  		/* If the mm is already defunct, don't handle faults. */
> >  		if (!mmget_not_zero(svm->mm))
> >  			goto bad_req;
> > @@ -892,24 +968,10 @@ static irqreturn_t prq_event_thread(int irq, void
> *d)
> >  			goto invalid;
> >
> >  		result = QI_RESP_SUCCESS;
> > -	invalid:
> > +invalid:
> >  		mmap_read_unlock(svm->mm);
> >  		mmput(svm->mm);
> > -	bad_req:
> > -		/* Accounting for major/minor faults? */
> > -		rcu_read_lock();
> > -		list_for_each_entry_rcu(sdev, &svm->devs, list) {
> > -			if (sdev->sid == req->rid)
> > -				break;
> > -		}
> > -		/* Other devices can go away, but the drivers are not
> > permitted
> > -		 * to unbind while any page faults might be in flight. So it's
> > -		 * OK to drop the 'lock' here now we have it. */
> 
> should we keep and move this comment to earlier sdev lookup? and
> regarding to guest unbind, ae we preventing the fault owner (outside
> of iommu driver) to unbind against in-flight fault request?
> 
> > -		rcu_read_unlock();
> > -
> > -		if (WARN_ON(&sdev->list == &svm->devs))
> > -			sdev = NULL;
> 
> similarly should we keep the WARN_ON check here?
> 
> > -
> > +bad_req:
> >  		if (sdev && sdev->ops && sdev->ops->fault_cb) {
> >  			int rwxp = (req->rd_req << 3) | (req->wr_req << 2) |
> >  				(req->exe_req << 1) | (req->pm_req);
> > @@ -920,7 +982,7 @@ static irqreturn_t prq_event_thread(int irq, void *d)
> >  		   and these can be NULL. Do not use them below this point!
> > */
> >  		sdev = NULL;
> >  		svm = NULL;
> > -	no_pasid:
> > +no_pasid:
> >  		if (req->lpig || req->priv_data_present) {
> >  			/*
> >  			 * Per VT-d spec. v3.0 ch7.7, system software must
> > @@ -945,6 +1007,7 @@ static irqreturn_t prq_event_thread(int irq, void
> *d)
> >  			resp.qw3 = 0;
> >  			qi_submit_sync(iommu, &resp, 1, 0);
> >  		}
> > +prq_advance:
> >  		head = (head + sizeof(*req)) & PRQ_RING_MASK;
> >  	}
> >
> > --
> > 2.17.1
> 
> Thanks
> Kevin