Re: [PATCH V5 0/3] Internal voltage control for qcom SDHC

[Ulf Hansson]

On Tue, 23 Jun 2020 at 15:35, Veerabhadrarao Badiganti
<vbadigan@xxxxxxxxxxxxxx> wrote:
>
> On qcom SD host controllers voltage switching be done after the HW
> is ready for it. The HW informs its readiness through power irq.
> The voltage switching should happen only then.
>
> So added support to register voltage regulators from the msm driver
> and use them.
>
> This patchset was posted long back but not actively pursued
> https://lore.kernel.org/linux-arm-msm/1539004739-32060-1-git-send-email-vbadigan@xxxxxxxxxxxxxx/
> So posting it as fresh patchset.
>
> Changes since V4:
>         - Added clear comments on condtion which allows either to
>           tunf off/on Vqmmc or to set load.
>         - Added mmc_card_removable() to the condtion whcih checks
>           if the card is eMMC or other card.
>         - Rerturning error for unsupported voltagtes in
>           sdhci_msm_start_signal_voltage_switch()
>         - Moved setting ios.power_mode to mmc_alloc_host().
>
> Changes since V3:
>         - Dropped reading of regulator load values from device tree.
>         - Dropped documentaiton chagne.
>         - Since only Vqmmc supply of eMMC would be kept On during suspend,
>           setting load only for this regulator so that it can go to LPM.
>           And since this Load reamins same, load value is hard-coded in the driver.
>
> Changes since V2:
>         - Removed redundant log from sdhci_msm_set_vmmc.
>         - Added the condition for skiping disabling of vqmmc for eMMC.
>         - Updated logic such that, setting load for vqmmc only if
>           it is kept ON.
>         - Retained ack by Adrian for second patch.
>         - Updated dt properties names as per Robs comments.
>
> Changes since V1:
>         - Removed setting load for Vmmc regulator while turning it on/off.
>           Instead setting the active load once during probe.
>         - Simplified handlng of supplies for BUS_ON/OFF cases in shci_msm_handle_pwr_irq().
>         - Moved common code out of switch case in sdhci_msm_start_signal_voltage_switch().
>         - Updated variable name to sdhci_core_to_disable_vqmmc.
>         - Updated pr_err logs to dev_err logs.
> Veerabhadrarao Badiganti (2):
>   mmc: core: Set default power mode in mmc_alloc_host
>   mmc: sdhci-msm: Use internal voltage control
>
> Vijay Viswanath (1):
>   mmc: sdhci: Allow platform controlled voltage switching
>
>  drivers/mmc/core/host.c      |   1 +
>  drivers/mmc/host/sdhci-msm.c | 206 +++++++++++++++++++++++++++++++++++++++++--
>  drivers/mmc/host/sdhci.c     |  32 ++++---
>  drivers/mmc/host/sdhci.h     |   1 +
>  4 files changed, 218 insertions(+), 22 deletions(-)
>

V5 applied for next (did some minor amendment to patch 2), thanks!

Kind regards
Uffe