Re: [PATCH 1/3 v2] usb: typec: tcpci: Support BIST test data mode for compliance.

[Guenter Roeck]

On 7/14/20 4:12 PM, Badhri Jagan Sridharan wrote:
> Quoting from TCPCI spec:
> "Setting this bit to 1 is intended to be used only when a USB compliance
> tester is using USB BIST Test Data to test the PHY layer of the TCPC. The
> TCPM should clear this bit when a disconnect is detected.
> 0: Normal Operation. Incoming messages enabled by RECEIVE_DETECT
> passed to TCPM via Alert.
> 1: BIST Test Mode. Incoming messages enabled by RECEIVE_DETECT
> result in GoodCRC response but may not be passed to the TCPM via
> Alert."
> 
> Signed-off-by: Badhri Jagan Sridharan <badhri@xxxxxxxxxx>

This needs to be the second patch in the series. The set_bist_data
callback doesn't exist yet.

Other than that, for the code itself:

Reviewed-by: Guenter Roeck <linux@xxxxxxxxxxxx>

> ---
> Version history:
> Changes since V1:(Guenter's suggestions)
> - Split the change into two: TCPM and TCPCI
> - Move BIST log to TCPM log
> - Alignment and column count changes
> ---
>  drivers/usb/typec/tcpm/tcpci.c | 9 +++++++++
>  drivers/usb/typec/tcpm/tcpci.h | 1 +
>  2 files changed, 10 insertions(+)
> 
> diff --git a/drivers/usb/typec/tcpm/tcpci.c b/drivers/usb/typec/tcpm/tcpci.c
> index 753645bb25273a..f57d91fd0e0924 100644
> --- a/drivers/usb/typec/tcpm/tcpci.c
> +++ b/drivers/usb/typec/tcpm/tcpci.c
> @@ -227,6 +227,14 @@ static int tcpci_set_vconn(struct tcpc_dev *tcpc, bool enable)
>  				enable ? TCPC_POWER_CTRL_VCONN_ENABLE : 0);
>  }
>  
> +static int tcpci_set_bist_data(struct tcpc_dev *tcpc, bool enable)
> +{
> +	struct tcpci *tcpci = tcpc_to_tcpci(tcpc);
> +
> +	return regmap_update_bits(tcpci->regmap, TCPC_TCPC_CTRL, TCPC_TCPC_CTRL_BIST_TM,
> +				 enable ? TCPC_TCPC_CTRL_BIST_TM : 0);
> +}
> +
>  static int tcpci_set_roles(struct tcpc_dev *tcpc, bool attached,
>  			   enum typec_role role, enum typec_data_role data)
>  {
> @@ -530,6 +538,7 @@ struct tcpci *tcpci_register_port(struct device *dev, struct tcpci_data *data)
>  	tcpci->tcpc.set_pd_rx = tcpci_set_pd_rx;
>  	tcpci->tcpc.set_roles = tcpci_set_roles;
>  	tcpci->tcpc.pd_transmit = tcpci_pd_transmit;
> +	tcpci->tcpc.set_bist_data = tcpci_set_bist_data;
>  
>  	err = tcpci_parse_config(tcpci);
>  	if (err < 0)
> diff --git a/drivers/usb/typec/tcpm/tcpci.h b/drivers/usb/typec/tcpm/tcpci.h
> index 303ebde265465c..11c36d086c8608 100644
> --- a/drivers/usb/typec/tcpm/tcpci.h
> +++ b/drivers/usb/typec/tcpm/tcpci.h
> @@ -36,6 +36,7 @@
>  
>  #define TCPC_TCPC_CTRL			0x19
>  #define TCPC_TCPC_CTRL_ORIENTATION	BIT(0)
> +#define TCPC_TCPC_CTRL_BIST_TM		BIT(1)
>  
>  #define TCPC_ROLE_CTRL			0x1a
>  #define TCPC_ROLE_CTRL_DRP		BIT(6)
>