Re: [PATCH v3] ARM: dts: imx6qdl-icore: Fix OTG_ID pin and sdcard detect

[Shawn Guo]

On Fri, Jul 17, 2020 at 01:33:52PM +0530, Suniel Mahesh wrote:
> From: Michael Trimarchi <michael@xxxxxxxxxxxxxxxxxxxx>
> 
> The current pin muxing scheme muxes GPIO_1 pad for USB_OTG_ID
> because of which when card is inserted, usb otg is enumerated
> and the card is never detected.
> 
> [   64.492645] cfg80211: failed to load regulatory.db
> [   64.492657] imx-sdma 20ec000.sdma: external firmware not found, using ROM firmware
> [   76.343711] ci_hdrc ci_hdrc.0: EHCI Host Controller
> [   76.349742] ci_hdrc ci_hdrc.0: new USB bus registered, assigned bus number 2
> [   76.388862] ci_hdrc ci_hdrc.0: USB 2.0 started, EHCI 1.00
> [   76.396650] usb usb2: New USB device found, idVendor=1d6b, idProduct=0002, bcdDevice= 5.08
> [   76.405412] usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
> [   76.412763] usb usb2: Product: EHCI Host Controller
> [   76.417666] usb usb2: Manufacturer: Linux 5.8.0-rc1-next-20200618 ehci_hcd
> [   76.424623] usb usb2: SerialNumber: ci_hdrc.0
> [   76.431755] hub 2-0:1.0: USB hub found
> [   76.435862] hub 2-0:1.0: 1 port detected
> 
> The TRM mentions GPIO_1 pad should be muxed/assigned for card detect
> and ENET_RX_ER pad for USB_OTG_ID for proper operation.
> 
> This patch fixes pin muxing as per TRM and is tested on a
> i.Core 1.5 MX6 DL SOM.
> 
> [   22.449165] mmc0: host does not support reading read-only switch, assuming write-enable
> [   22.459992] mmc0: new high speed SDHC card at address 0001
> [   22.469725] mmcblk0: mmc0:0001 EB1QT 29.8 GiB
> [   22.478856]  mmcblk0: p1 p2
> 
> Fixes: 6df11287f7c9 ("ARM: dts: imx6q: Add Engicam i.CoreM6 Quad/Dual initial support")
> Cc: stable@xxxxxxxxxxxxxxx
> Signed-off-by: Michael Trimarchi <michael@xxxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Suniel Mahesh <sunil@xxxxxxxxxxxxxxxxxxxx>

Applied, thanks.