Re: kworker/0:3+pm hogging CPU

[Alan Stern]

On Mon, Jul 20, 2020 at 07:45:30PM +0200, Michal Hocko wrote:
> On Mon 20-07-20 13:38:07, Alan Stern wrote:
> > On Mon, Jul 20, 2020 at 06:33:55PM +0200, Michal Hocko wrote:
> > > On Mon 20-07-20 11:12:55, Alan Stern wrote:
> > > [...]
> > > > 	sudo echo 'module usbcore =p' >/debug/dynamic_debug/control
> > > > 
> > > > Then wait long enough for some interesting messages to appear in the 
> > > > kernel log (it should only take a few seconds if the worker thread is as 
> > > > busy as you say) and collect the output from the dmesg command.
> > > > 
> > > > To turn dynamic debugging back off when you're finished, use the same 
> > > > command with "=p" changed to "-p".
> > > 
> > > [   95.395815] hub 2-0:1.0: state 7 ports 6 chg 0006 evt 0000
> > > [   95.395824] usb usb2-port1: status 0088, change 0000, 5.0 Gb/s
> > > [   95.395838] usb usb2-port2: status 0088, change 0000, 5.0 Gb/s
> > > [   95.396016] hub 2-0:1.0: hub_suspend
> > > [   95.396023] usb usb2: bus auto-suspend, wakeup 1
> > > [   95.396029] usb usb2: bus suspend fail, err -16
> > 
> > Okay, that's the problem.  You may get more specific information about 
> > the suspend failure if you turn on dynamic debugging for the xhci-hcd 
> > module (same command as above but with xhci-hcd instead of usbcore).
> 
> Would that help to pinpoint the problem down?

It might.  I can't say for sure without seeing the output.

Alan Stern