Re: [Linux-stm32] [PATCH v3 3/3] ARM: dts: stm32: add initial support for stm32mp157-odyssey board

[Marcin SÅoniewski]

Hi Christophe,

> > +     pinctrl-names = "default", "opendrain", "sleep";
> > +     pinctrl-0 = <&sdmmc2_b4_pins_a &sdmmc2_d47_pins_a>;
> > +     pinctrl-1 = <&sdmmc2_b4_od_pins_a &sdmmc2_d47_pins_a>;
> > +     pinctrl-2 = <&sdmmc2_b4_sleep_pins_a &sdmmc2_d47_sleep_pins_a>;
> > +     non-removable;
> > +     no-sd;
> > +     no-sdio;
> > +     st,neg-edge;
> > +     bus-width = <4>;
> > +     vmmc-supply = <&v3v3>;
> > +     vqmmc-supply = <&v3v3>;
> > +     mmc-ddr-3_3v;
> > +     status = "okay";
> > +};
>
> Based on the pins muxed, 8 data lines are configured, but the bus width
> is set to 4. What is the reason of not setting this property to 8?

Yes, it was workaround, because sdmmc2 interface was working only
with width set to 4. It turned out there was one wrong pin used in
sdmmc2_d47_pins_a.
It will be fixed in v4.

Regards,
Marcin Sloniewski