Re: [PATCH v3 2/2] power: supply: sbs-battery: don't assume i2c errors as battery disconnect

[Nicolas Boichat]

On Thu, Aug 13, 2020 at 1:11 PM Ikjoon Jang <ikjn@xxxxxxxxxxxx> wrote:
>
> Current sbs-battery considers all smbus errors as disconnection events
> when battery-detect pin isn't supplied, and restored to present state back
> when any successful transaction is made.
>
> This can lead to unlimited state changes between present and !present
> when one unsupported command was requested and other following commands
> were successful, e.g. udev rules tries to read multiple properties.
>
> This patch checks battery presence by reading known good command to
> check battery existence.
>
> Signed-off-by: Ikjoon Jang <ikjn@xxxxxxxxxxxx>

Looks good now, AFAICT. Thanks!

Reviewed-by: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>

> ---
>  drivers/power/supply/sbs-battery.c | 25 +++++++++++++++++--------
>  1 file changed, 17 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/power/supply/sbs-battery.c b/drivers/power/supply/sbs-battery.c
> index 6acb4ea25d2a..2e32fde04628 100644
> --- a/drivers/power/supply/sbs-battery.c
> +++ b/drivers/power/supply/sbs-battery.c
> @@ -878,10 +878,17 @@ static int sbs_get_property(struct power_supply *psy,
>         if (!chip->enable_detection)
>                 goto done;
>
> -       if (!chip->gpio_detect &&
> -               chip->is_present != (ret >= 0)) {
> -               sbs_update_presence(chip, (ret >= 0));
> -               power_supply_changed(chip->power_supply);
> +       if (!chip->gpio_detect && chip->is_present != (ret >= 0)) {
> +               bool old_present = chip->is_present;
> +               union power_supply_propval val;
> +
> +               ret = sbs_get_battery_presence_and_health(
> +                               client, POWER_SUPPLY_PROP_PRESENT, &val);
> +
> +               sbs_update_presence(chip, !ret && val.intval);
> +
> +               if (old_present != chip->is_present)
> +                       power_supply_changed(chip->power_supply);
>         }
>
>  done:
> @@ -1067,11 +1074,13 @@ static int sbs_probe(struct i2c_client *client)
>          * to the battery.
>          */
>         if (!(force_load || chip->gpio_detect)) {
> -               rc = sbs_read_word_data(client, sbs_data[REG_STATUS].addr);
> +               union power_supply_propval val;
>
> -               if (rc < 0) {
> -                       dev_err(&client->dev, "%s: Failed to get device status\n",
> -                               __func__);
> +               rc = sbs_get_battery_presence_and_health(
> +                               client, POWER_SUPPLY_PROP_PRESENT, &val);
> +               if (rc < 0 || !val.intval) {
> +                       dev_err(&client->dev, "Failed to get present status\n");
> +                       rc = -ENODEV;
>                         goto exit_psupply;
>                 }
>         }
> --
> 2.28.0.236.gb10cc79966-goog
>