[PATCH 4.19 161/168] mtd: rawnand: qcom: avoid write to unavailable register

[Greg Kroah-Hartman]

From: Sivaprakash Murugesan <sivaprak@xxxxxxxxxxxxxx>

commit 443440cc4a901af462239d286cd10721aa1c7dfc upstream.

SFLASHC_BURST_CFG is only available on older ipq NAND platforms, this
register has been removed when the NAND controller got implemented in
the qpic controller.

Avoid writing this register on devices which are based on qpic NAND
controller.

Fixes: dce84760b09f ("mtd: nand: qcom: Support for IPQ8074 QPIC NAND controller")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Sivaprakash Murugesan <sivaprak@xxxxxxxxxxxxxx>
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Link: https://lore.kernel.org/linux-mtd/1591948696-16015-2-git-send-email-sivaprak@xxxxxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>

---
 drivers/mtd/nand/raw/qcom_nandc.c |    7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -466,11 +466,13 @@ struct qcom_nand_host {
  * among different NAND controllers.
  * @ecc_modes - ecc mode for NAND
  * @is_bam - whether NAND controller is using BAM
+ * @is_qpic - whether NAND CTRL is part of qpic IP
  * @dev_cmd_reg_start - NAND_DEV_CMD_* registers starting offset
  */
 struct qcom_nandc_props {
 	u32 ecc_modes;
 	bool is_bam;
+	bool is_qpic;
 	u32 dev_cmd_reg_start;
 };
 
@@ -2766,7 +2768,8 @@ static int qcom_nandc_setup(struct qcom_
 	u32 nand_ctrl;
 
 	/* kill onenand */
-	nandc_write(nandc, SFLASHC_BURST_CFG, 0);
+	if (!nandc->props->is_qpic)
+		nandc_write(nandc, SFLASHC_BURST_CFG, 0);
 	nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD),
 		    NAND_DEV_CMD_VLD_VAL);
 
@@ -3022,12 +3025,14 @@ static const struct qcom_nandc_props ipq
 static const struct qcom_nandc_props ipq4019_nandc_props = {
 	.ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
 	.is_bam = true,
+	.is_qpic = true,
 	.dev_cmd_reg_start = 0x0,
 };
 
 static const struct qcom_nandc_props ipq8074_nandc_props = {
 	.ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
 	.is_bam = true,
+	.is_qpic = true,
 	.dev_cmd_reg_start = 0x7000,
 };