Re: [PATCH V2] ARM: dts: omap3: Add cpu trips and cooling map for omap34/36 families

[Tony Lindgren]

* Andreas Kemnade <andreas@xxxxxxxxxxxx> [200817 20:15]:
> On Mon, 17 Aug 2020 15:02:27 -0500
> Adam Ford <aford173@xxxxxxxxx> wrote:
> 
> > On Mon, Aug 17, 2020 at 2:59 PM Andreas Kemnade <andreas@xxxxxxxxxxxx> wrote:
> > >
> > > On Mon, 17 Aug 2020 08:39:31 -0500
> > > Adam Ford <aford173@xxxxxxxxx> wrote:
> > >  
> > > > The OMAP3530, OMAP3630, and DM3730 all show thresholds of 90C and 105C
> > > > depending on commercial or industrial temperature ratings.
> > > >
> > > > This patch expands the thermal information to include the limits of 90
> > > > and 105C for alert and critical.  It sets the coolings-cells for the
> > > > 34xx and 36xx CPU's which both point to omap3-cpu-thermal.dtsi.
> > > >
> > > > For boards who never use industrial temperatures, these can be
> > > > changed on their respective device trees with something like:
> > > >
> > > > &cpu_alert0 {
> > > >       temperature = <85000>; /* millicelsius */
> > > > };
> > > >
> > > > &cpu_crit {
> > > >       temperature = <90000>; /* millicelsius */
> > > > };

I think you should set the lower temperatures by default and have
only the boards known to work with higher values configure them as
needed.

> > > > OMAP3_THERMAL will need to be enabled.  It is off by default.
> > > >  
> > > hmm, I think the patch for idling core when OMAP3_THERMAL is enabled
> > > got stuck somewhere. It still seems not to work. Shouldn't that patch
> > > be applied first?  
> > 
> > I rebased the idle stuff, and now I get errors, so I haven't pushed it
> > yet.  I put a note that OMAP3_THERMAL is off by default, but this
> > patch would at least get the framing in there.  I know at least two of
> > us that use 1GHZ processors which are not supposed to run at that
> > speed above 90MHz, so the idea was to tolerate the higher current for
> > now, and when the idle stuff works, we'll enable the OMAP3_THERMAL by
> > default.
> > 
> yes, makes sense, so with this patch we have the choice to either
> optimize for low speeds and currents (by disabling OMAP3_THERMAL and
> 1GHz) or high speeds (by enabling OMAP3_THERMAL and 1 Ghz).

Maybe add something like that to the patch description too?

Regards,

Tony