[PATCH 05/11] soundwire: bus: update multi-link definition with hw sync details

[Bard Liao]

From: Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxxxxxxxx>

Hardware-based synchronization is typically required when the
bus->multi_link flag is set.

On Intel platforms, when the Cadence IP is configured in 'Multi Master
Mode', the hardware synchronization is required even when a stream
only uses a single segment. The existing code only deal with hardware
synchronization when a stream uses more than one segment so to remain
backwards compatible we add a configuration threshold. For Intel cases
this threshold will be set to one, other platforms may be able to use
the SSP-based sync in those cases.

Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxxxxxxxx>
Signed-off-by: Bard Liao <yung-chuan.liao@xxxxxxxxxxxxxxx>
---
 include/linux/soundwire/sdw.h | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/include/linux/soundwire/sdw.h b/include/linux/soundwire/sdw.h
index 76052f12c9f7..9adbe4fd7980 100644
--- a/include/linux/soundwire/sdw.h
+++ b/include/linux/soundwire/sdw.h
@@ -827,6 +827,11 @@ struct sdw_master_ops {
  * @multi_link: Store bus property that indicates if multi links
  * are supported. This flag is populated by drivers after reading
  * appropriate firmware (ACPI/DT).
+ * @hw_sync_min_links: Number of links used by a stream above which
+ * hardware-based synchronization is required. This value is only
+ * meaningful if multi_link is set. If set to 1, hardware-based
+ * synchronization will be used even if a stream only uses a single
+ * SoundWire segment.
  */
 struct sdw_bus {
 	struct device *dev;
@@ -850,6 +855,7 @@ struct sdw_bus {
 	unsigned int clk_stop_timeout;
 	u32 bank_switch_timeout;
 	bool multi_link;
+	int hw_sync_min_links;
 };
 
 int sdw_bus_master_add(struct sdw_bus *bus, struct device *parent,
-- 
2.17.1