Re: [PATCH net-next v2 3/7] net: dsa: mt7530: Extend device data ready for adding a new hardware

[Andrew Lunn]

On Tue, Aug 18, 2020 at 03:14:08PM +0800, Landen Chao wrote:
> Add a structure holding required operations for each device such as device
> initialization, PHY port read or write, a checker whether PHY interface is
> supported on a certain port, MAC port setup for either bus pad or a
> specific PHY interface.
> 
> The patch is done for ready adding a new hardware MT7531.
> 
> Signed-off-by: Landen Chao <landen.chao@xxxxxxxxxxxx>
> Signed-off-by: Sean Wang <sean.wang@xxxxxxxxxxxx>
> ---
>  drivers/net/dsa/mt7530.c | 272 +++++++++++++++++++++++++++++----------
>  drivers/net/dsa/mt7530.h |  37 +++++-
>  2 files changed, 240 insertions(+), 69 deletions(-)
> 
> diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
> index 0fd50798aa42..d30b41725b4d 100644
> --- a/drivers/net/dsa/mt7530.c
> +++ b/drivers/net/dsa/mt7530.c
> @@ -372,8 +372,9 @@ mt7530_fdb_write(struct mt7530_priv *priv, u16 vid,
>  		mt7530_write(priv, MT7530_ATA1 + (i * 4), reg[i]);
>  }
>  
> +/* Setup TX circuit incluing relevant PAD and driving */
>  static int
> -mt7530_pad_clk_setup(struct dsa_switch *ds, int mode)
> +mt7530_pad_clk_setup(struct dsa_switch *ds, phy_interface_t interface)
>  {
>  	struct mt7530_priv *priv = ds->priv;
>  	u32 ncpo1, ssc_delta, trgint, i, xtal;
> @@ -387,7 +388,7 @@ mt7530_pad_clk_setup(struct dsa_switch *ds, int mode)
>  		return -EINVAL;
>  	}
>  
> -	switch (mode) {
> +	switch (interface) {
>  	case PHY_INTERFACE_MODE_RGMII:
>  		trgint = 0;
>  		/* PLL frequency: 125MHz */

Do you actually need to support all 4 RGMII modes?

...

+			goto unsupported;
> +		break;
> +	case 6: /* 1st cpu port */
> +		if (state->interface != PHY_INTERFACE_MODE_RGMII &&
> +		    state->interface != PHY_INTERFACE_MODE_TRGMII)

phy_interface_mode_is_rgmii()?

	Andrew