[PATCH 3/5] arm64: dts: imx8mq-phanbell: Replace deprecated phy reset properties

[Krzysztof Kozlowski]

Use preferred properties of phy node instead of deprecated
phy-reset-gpios (and others).  This avoids copying deprecated code into
future DTSes.

Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>

---

Not tested on HW.
---
 arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
index 77ab568fae67..3f541ddf0768 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
@@ -262,9 +262,6 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_fec1>;
 	phy-mode = "rgmii-id";
-	phy-reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
-	phy-reset-duration = <10>;
-	phy-reset-post-delay = <50>;
 	phy-handle = <&ethphy0>;
 	fsl,magic-packet;
 	status = "okay";
@@ -275,6 +272,9 @@
 		ethphy0: ethernet-phy@0 {
 			compatible = "ethernet-phy-ieee802.3-c22";
 			reg = <0>;
+			reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <50000>;
 		};
 	};
 };
-- 
2.17.1