[PATCH 2/4] dt-bindings: net: nfc: s3fwrn5: Remove wrong vendor prefix from GPIOs

[Krzysztof Kozlowski]

The device tree property prefix describes the vendor, which in case of
S3FWRN5 chip is Samsung.  Therefore the "s3fwrn5" prefix for "en-gpios"
and "fw-gpios" is not correct and should be deprecated.  Introduce
properly named properties for these GPIOs and rename the fw-gpios" to
"wake-gpios" to better describe its purpose.

Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
 .../devicetree/bindings/net/nfc/s3fwrn5.yaml  | 24 ++++++++++++++-----
 1 file changed, 18 insertions(+), 6 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/nfc/s3fwrn5.yaml b/Documentation/devicetree/bindings/net/nfc/s3fwrn5.yaml
index c22451dea350..1f13b4553db4 100644
--- a/Documentation/devicetree/bindings/net/nfc/s3fwrn5.yaml
+++ b/Documentation/devicetree/bindings/net/nfc/s3fwrn5.yaml
@@ -14,28 +14,40 @@ properties:
   compatible:
     const: samsung,s3fwrn5-i2c
 
+  en-gpios:
+    maxItems: 1
+    description:
+      Output GPIO pin used for enabling/disabling the chip
+
   interrupts:
     maxItems: 1
 
   reg:
     maxItems: 1
 
+  wake-gpios:
+    maxItems: 1
+    description:
+      Output GPIO pin used to enter firmware mode and sleep/wakeup control
+
   s3fwrn5,en-gpios:
     maxItems: 1
+    deprecated: true
     description:
-      Output GPIO pin used for enabling/disabling the chip
+      Use en-gpios
 
   s3fwrn5,fw-gpios:
     maxItems: 1
+    deprecated: true
     description:
-      Output GPIO pin used to enter firmware mode and sleep/wakeup control
+      Use wake-gpios
 
 required:
   - compatible
+  - en-gpios
   - interrupts
   - reg
-  - s3fwrn5,en-gpios
-  - s3fwrn5,fw-gpios
+  - wake-gpios
 
 examples:
   - |
@@ -53,7 +65,7 @@ examples:
             interrupt-parent = <&gpa1>;
             interrupts = <3 IRQ_TYPE_LEVEL_HIGH>;
 
-            s3fwrn5,en-gpios = <&gpf1 4 GPIO_ACTIVE_HIGH>;
-            s3fwrn5,fw-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
+            en-gpios = <&gpf1 4 GPIO_ACTIVE_HIGH>;
+            wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
         };
     };
-- 
2.17.1