[PATCH 18/33] ARM: dts: exynos: Override thermal by label in Trats

[Krzysztof Kozlowski]

Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired.  This will lead to run-time errors
that could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).

Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
 arch/arm/boot/dts/exynos4210-trats.dts | 29 ++++++++++++--------------
 1 file changed, 13 insertions(+), 16 deletions(-)

diff --git a/arch/arm/boot/dts/exynos4210-trats.dts b/arch/arm/boot/dts/exynos4210-trats.dts
index 33b40f619dea..75483e08b4b4 100644
--- a/arch/arm/boot/dts/exynos4210-trats.dts
+++ b/arch/arm/boot/dts/exynos4210-trats.dts
@@ -140,22 +140,6 @@
 			clock-frequency = <32768>;
 		};
 	};
-
-	thermal-zones {
-		cpu_thermal: cpu-thermal {
-			cooling-maps {
-				map0 {
-				     /* Corresponds to 800MHz at freq_table */
-				     cooling-device = <&cpu0 2 2>, <&cpu1 2 2>;
-				};
-				map1 {
-				     /* Corresponds to 200MHz at freq_table */
-				     cooling-device = <&cpu0 4 4>, <&cpu1 4 4>;
-			       };
-		       };
-		};
-	};
-
 };
 
 &camera {
@@ -166,6 +150,19 @@
 	cpu0-supply = <&varm_breg>;
 };
 
+&cpu_thermal {
+	cooling-maps {
+		map0 {
+			/* Corresponds to 800MHz at freq_table */
+			cooling-device = <&cpu0 2 2>, <&cpu1 2 2>;
+		};
+		map1 {
+			/* Corresponds to 200MHz at freq_table */
+			cooling-device = <&cpu0 4 4>, <&cpu1 4 4>;
+		};
+	};
+};
+
 &dsi_0 {
 	vddcore-supply = <&vusb_reg>;
 	vddio-supply = <&vmipi_reg>;
-- 
2.17.1