Re: [Intel-wired-lan] VRRP not working on i40e X722 S2600WFT

[Jesse Brandeburg]

Lennart Sorensen wrote:

> On Thu, Aug 27, 2020 at 02:30:39PM -0400, Lennart Sorensen wrote:
> > I have hit a new problem with the X722 chipset (Intel R1304WFT server).
> > VRRP simply does not work.
> > 
> > When keepalived registers a vmac interface, and starts transmitting
> > multicast packets with the vrp message, it never receives those packets
> > from the peers, so all nodes think they are the master.  tcpdump shows
> > transmits, but no receives.  If I stop keepalived, which deletes the
> > vmac interface, then I start to receive the multicast packets from the
> > other nodes.  Even in promisc mode, tcpdump can't see those packets.
> > 
> > So it seems the hardware is dropping all packets with a source mac that
> > matches the source mac of the vmac interface, even when the destination
> > is a multicast address that was subcribed to.  This is clearly not
> > proper behaviour.

Thanks for the report Lennart, I understand your frustration, as this
should probably work without user configuration.

However, please give this command a try:
ethtool --set-priv-flags ethX disable-source-pruning on


> > I tried a stock 5.8 kernel to check if a driver update helped, and updated
> > the nvm firware to the latest 4.10 (which appears to be over a year old),
> > and nothing changes the behaviour at all.
> > 
> > Seems other people have hit this problem too:
> > http://mails.dpdk.org/archives/users/2018-May/003128.html
> > 
> > Unless someone has a way to fix this, we will have to change away from
> > this hardware very quickly.  The IPsec NAT RSS defect we could tolerate
> > although didn't like, while this is just unworkable.
> > 
> > Quite frustrated by this.  Intel network hardware was always great,
> > how did the X722 make it out in this state.
> 
> Another case with the same problem on an X710:
> 
> https://www.talkend.net/post/13256.html

I don't know how to reply to this other thread, but it is about DPDK,
which would require a code change or further investigation to issue the
right command to the hardware to disable source pruning.