[PATCH v6 13/14] usb: typec: tcpci: Implement Auto discharge disconnect callbacks

[Badhri Jagan Sridharan]

Implement callbacks for enabling/disabling
POWER_CONTROL.AutoDischargeDisconnect.

TCPCI spec allows TCPC hardware to autonomously discharge the vbus
capacitance upon disconnect. The expectation is that the TCPM enables
AutoDischargeDisconnect while entering SNK/SRC_ATTACHED states. Hardware
then automously discharges vbus when the vbus falls below a certain
threshold i.e. VBUS_SINK_DISCONNECT_THRESHOLD.

Apart from enabling the vbus discharge circuit, AutoDischargeDisconnect
is also used a flag to move TCPCI based TCPC implementations into
Attached.Snk/Attached.Src state as mentioned in
Figure 4-15. TCPC State Diagram before a Connection of the
USB Type-C Port Controller Interface Specification.
In such TCPC implementations, setting AutoDischargeDisconnect would
prevent TCPC into entering "Connection_Invalid" state as well.

Signed-off-by: Badhri Jagan Sridharan <badhri@xxxxxxxxxx>
---
Changes since v1:
- Changing patch version to v6 to fix version number confusion.
---
 drivers/usb/typec/tcpm/tcpci.c | 33 +++++++++++++++++++++++++++++++++
 drivers/usb/typec/tcpm/tcpci.h | 22 ++++++++++++++++++++--
 2 files changed, 53 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/typec/tcpm/tcpci.c b/drivers/usb/typec/tcpm/tcpci.c
index f9f0af64da5f..4ca64e8c8fe8 100644
--- a/drivers/usb/typec/tcpm/tcpci.c
+++ b/drivers/usb/typec/tcpm/tcpci.c
@@ -268,6 +268,33 @@ static int tcpci_set_vconn(struct tcpc_dev *tcpc, bool enable)
 				enable ? TCPC_POWER_CTRL_VCONN_ENABLE : 0);
 }
 
+static int tcpci_enable_auto_vbus_discharge(struct tcpc_dev *dev, bool enable)
+{
+	struct tcpci *tcpci = tcpc_to_tcpci(dev);
+	int ret;
+
+	ret = regmap_update_bits(tcpci->regmap, TCPC_POWER_CTRL, TCPC_POWER_CTRL_AUTO_DISCHARGE,
+				 enable ? TCPC_POWER_CTRL_AUTO_DISCHARGE : 0);
+	return ret;
+}
+
+static int tcpci_set_auto_vbus_discharge_threshold(struct tcpc_dev *dev, enum typec_role port_role,
+						   enum typec_pwr_opmode mode, bool pps_active,
+						   u32 requested_vbus_voltage)
+{
+	struct tcpci *tcpci = tcpc_to_tcpci(dev);
+	int (*set_auto_vbus_threshold)(struct tcpci *tcpci, struct tcpci_data *data,
+				       enum typec_role port_role, enum typec_pwr_opmode mode,
+				       bool pps_active, u32 requested_vbus_voltage);
+
+	set_auto_vbus_threshold = tcpci->data->set_auto_vbus_discharge_threshold;
+	if (set_auto_vbus_threshold)
+		return set_auto_vbus_threshold(tcpci, tcpci->data, port_role, mode, pps_active,
+					       requested_vbus_voltage);
+
+	return 0;
+}
+
 static int tcpci_enable_frs(struct tcpc_dev *dev, bool enable)
 {
 	struct tcpci *tcpci = tcpc_to_tcpci(dev);
@@ -629,6 +656,12 @@ struct tcpci *tcpci_register_port(struct device *dev, struct tcpci_data *data)
 	tcpci->tcpc.set_bist_data = tcpci_set_bist_data;
 	tcpci->tcpc.enable_frs = tcpci_enable_frs;
 
+	if (tcpci->data->auto_discharge_disconnect) {
+		tcpci->tcpc.enable_auto_vbus_discharge = tcpci_enable_auto_vbus_discharge;
+		tcpci->tcpc.set_auto_vbus_discharge_threshold =
+			tcpci_set_auto_vbus_discharge_threshold;
+	}
+
 	err = tcpci_parse_config(tcpci);
 	if (err < 0)
 		return ERR_PTR(err);
diff --git a/drivers/usb/typec/tcpm/tcpci.h b/drivers/usb/typec/tcpm/tcpci.h
index 5ef07a56d67a..6a0aea34e544 100644
--- a/drivers/usb/typec/tcpm/tcpci.h
+++ b/drivers/usb/typec/tcpm/tcpci.h
@@ -8,6 +8,8 @@
 #ifndef __LINUX_USB_TCPCI_H
 #define __LINUX_USB_TCPCI_H
 
+#include <linux/usb/typec.h>
+
 #define TCPC_VENDOR_ID			0x0
 #define TCPC_PRODUCT_ID			0x2
 #define TCPC_BCD_DEV			0x4
@@ -67,6 +69,7 @@
 
 #define TCPC_POWER_CTRL			0x1c
 #define TCPC_POWER_CTRL_VCONN_ENABLE	BIT(0)
+#define TCPC_POWER_CTRL_AUTO_DISCHARGE	BIT(4)
 #define TCPC_FAST_ROLE_SWAP_EN		BIT(7)
 
 #define TCPC_CC_STATUS			0x1d
@@ -133,6 +136,8 @@
 
 #define TCPC_VBUS_VOLTAGE			0x70
 #define TCPC_VBUS_SINK_DISCONNECT_THRESH	0x72
+#define TCPC_VBUS_SINK_DISCONNECT_THRESH_LSB	25
+#define TCPC_VBUS_SINK_DISCONNECT_THRESH_MAX	1023
 #define TCPC_VBUS_STOP_DISCHARGE_THRESH		0x74
 #define TCPC_VBUS_VOLTAGE_ALARM_HI_CFG		0x76
 #define TCPC_VBUS_VOLTAGE_ALARM_LO_CFG		0x78
@@ -140,20 +145,33 @@
 /* I2C_WRITE_BYTE_COUNT + 1 when TX_BUF_BYTE_x is only accessible I2C_WRITE_BYTE_COUNT */
 #define TCPC_TRANSMIT_BUFFER_MAX_LEN		31
 
+struct tcpci;
+
 /*
- * @TX_BUF_BYTE_x_hidden
+ * @TX_BUF_BYTE_x_hidden:
  *		optional; Set when TX_BUF_BYTE_x can only be accessed through I2C_WRITE_BYTE_COUNT.
+ * @auto_discharge_disconnect:
+ *		Optional; Enables TCPC to autonously discharge vbus on disconnect.
+ * @set_auto_vbus_discharge_threshold:
+ *		Mandatory when @auto_discharge_disconnect is sets. Allows
+ *		programming the voltage threshold of vbus below which TCPC
+ *		enables the vbus discharge circuit.
  */
-struct tcpci;
 struct tcpci_data {
 	struct regmap *regmap;
 	unsigned char TX_BUF_BYTE_x_hidden:1;
+	unsigned char auto_discharge_disconnect:1;
+
 	int (*init)(struct tcpci *tcpci, struct tcpci_data *data);
 	int (*set_vconn)(struct tcpci *tcpci, struct tcpci_data *data,
 			 bool enable);
 	int (*start_drp_toggling)(struct tcpci *tcpci, struct tcpci_data *data,
 				  enum typec_cc_status cc);
 	int (*set_vbus)(struct tcpci *tcpci, struct tcpci_data *data, bool source, bool sink);
+	int (*set_auto_vbus_discharge_threshold)(struct tcpci *tcpci, struct tcpci_data *data,
+						 enum typec_role port_role,
+						 enum typec_pwr_opmode mode, bool pps_active,
+						 u32 requested_vbus_voltage);
 };
 
 struct tcpci *tcpci_register_port(struct device *dev, struct tcpci_data *data);
-- 
2.28.0.402.g5ffc5be6b7-goog