Re: [PATCH 1/2] dt-bindings: interrupt-controller: add Hisilicon SD5203 vector interrupt controller

[Leizhen (ThunderTown)]

On 2020/9/15 4:31, Rob Herring wrote:
> On Thu, Sep 03, 2020 at 08:05:03PM +0800, Zhen Lei wrote:
>> Add DT bindings for the Hisilicon SD5203 vector interrupt controller.
>>
>> Signed-off-by: Zhen Lei <thunder.leizhen@xxxxxxxxxx>
>> ---
>>  .../hisilicon,sd5203-vic.txt                  | 27 +++++++++++++++++++
> 
> Bindings should be in DT schema format now.

Hi, Rob Herring:

As Marc Zyngier's suggestion, I discarded adding an independent SD5203-VIC
driver, but make the dw-apb-ictl irqchip driver to support hierarchy irq domain.
So this new file was also dropped. Now, I updated the descriptions in the existing
file "snps,dw-apb-ictl.txt" in the following versions.

> 
>>  1 file changed, 27 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt
>>
>> diff --git a/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt
>> new file mode 100644
>> index 000000000000..a08292e868b0
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt
>> @@ -0,0 +1,27 @@
>> +Hisilicon SD5203 vector interrupt controller (VIC)
>> +
>> +Hisilicon SD5203 VIC based on Synopsys DesignWare APB interrupt controller, but
>> +there's something special:
>> +1. The maximum number of irqs supported is 32. The registers ENABLE, MASK and
>> +   FINALSTATUS are 32 bits.
>> +2. There is only one VIC, it's used as primary interrupt controller.
>> +
>> +Required properties:
>> +- compatible: shall be "hisilicon,sd5203-vic"
>> +- reg: physical base address of the controller and length of memory mapped
>> +  region starting with ENABLE_LOW register
>> +- interrupt-controller: identifies the node as an interrupt controller
>> +- #interrupt-cells: number of cells to encode an interrupt-specifier, shall be 1
>> +
>> +The interrupt sources map to the corresponding bits in the interrupt
>> +registers, i.e.
>> +- 0 maps to bit 0 of low interrupts,
>> +- 1 maps to bit 1 of low interrupts,
>> +
>> +Example:
>> +	vic: interrupt-controller@10130000 {
>> +		compatible = "hisilicon,sd5203-vic";
>> +		reg = <0x10130000 0x1000>;
>> +		interrupt-controller;
>> +		#interrupt-cells = <1>;
>> +	};
>> -- 
>> 2.26.0.106.g9fadedd
>>
>>
> 
> .
>