Re: [PATCH] net: phy: realtek: fix rtl8211e rx/tx delay config

[Andrew Lunn]

On Fri, Sep 18, 2020 at 06:55:16AM +0000, 劉偉權 wrote:
> Hi Serge,

> Thanks for your reply. There is a confidential issue that realtek
> doesn't offer the detail of a full register layout for configuration
> register.

...

> >  	 * 0xa4 extension page (0x7) layout. It can be used to disable/enable
> >  	 * the RX/TX delays otherwise controlled by RXDLY/TXDLY pins. It can
> >  	 * also be used to customize the whole configuration register:
> 
> > -	 * 8:6 = PHY Address, 5:4 = Auto-Negotiation, 3 = Interface Mode Select,
> > -	 * 2 = RX Delay, 1 = TX Delay, 0 = SELRGV (see original PHY datasheet
> > -	 * for details).
> > +	 * 13 = Force Tx RX Delay controlled by bit12 bit11,
> > +	 * 12 = RX Delay, 11 = TX Delay
> 

> Here you've removed the register layout description and replaced itq
> with just three bits info. So from now the text above doesn't really
> corresponds to what follows.

> I might have forgotten something, but AFAIR that register bits
> stateq mapped well to what was available on the corresponding
> external pins.

Hi Willy

So it appears bits 3 to 8 have been reverse engineered. Unless you
know from your confidential datasheet that these are wrong, please
leave the comment alone.

If you confidential datasheet says that the usage of bits 0-2 is
wrong, then please do correct that part.

       Andrew