Re: [PATCH v2 1/2] PM / Domains: Add GENPD_FLAG_NO_SUSPEND/RESUME flags

[Rafael J. Wysocki]

On Tue, Sep 22, 2020 at 6:51 AM Sibi Sankar <sibis@xxxxxxxxxxxxxx> wrote:
>
> On 2020-09-22 01:26, Stephen Boyd wrote:
> > Quoting Rafael J. Wysocki (2020-09-21 09:18:17)
> >> On Fri, Aug 21, 2020 at 10:49 PM Sibi Sankar <sibis@xxxxxxxxxxxxxx>
> >> wrote:
> >> >
> >> > Add GENPD_FLAG_NO_SUSPEND/RESUME flags to instruct genpd to keep the
> >> > status of the PM domain unaltered during suspend/resume respectively.
> >> > The flags are aimed at power domains coupled to co-processors which
> >> > enter low-power modes independent to that of the application processor.
> >> >
> >> > Specifically the flags are to be used by the power domains exposed
> >> > by the AOSS QMP driver linked to modem, adsp, cdsp remoteprocs. These
> >> > power domains are used to notify the Always on Subsystem (AOSS) that
> >> > a particular co-processor is up. AOSS uses this information to wait
> >> > for the co-processors to suspend before starting its sleep sequence.
> >> > The application processor powers off these power domains only if the
> >> > co-processor has crashed or powered off and remains unaltered during
> >> > system suspend/resume.
> >> >
> >> > Signed-off-by: Sibi Sankar <sibis@xxxxxxxxxxxxxx>
> >>
> >> Applied with the Ulf's R-by along with the [2/2] as 5.10 material,
> >> thanks!
> >>
> >
> > There was a bunch of discussion on this patch series and I thought the
> > consensus was to not apply these patches and instead implement a custom
> > qcom specific API that does this instead.
>
> https://lore.kernel.org/lkml/20200913034603.GV3715@yoga/
>
> The power domains which were targeted
> to use the flags will be replaced by
> custom qcom specific API. So let's not
> pick up the patch series.

OK, I'm dropping it then, thanks!