[PATCH 0/7] Pine64 PineCube support

[Icenowy Zheng]

Pine64 PineCube is an IP camera based on Allwinner S3 chip.

This patchset tries to add support for it.

In order to make sure the system do not hang when camera is brought up,
a fix to AXP209 driver is needed (sent individually), otherwise the
system will hang because it changes the voltage of LDO2 when LDO4
tweaking.

Icenowy Zheng (7):
  ARM: dts: sun8i: V3/V3s/S3/S3L: add Ethernet support
  ARM: dts: sun8i: V3/V3s/S3/S3L: add pinctrl for UART2 RX/TX
  ARM: dts: sun8i: V3/V3s/S3/S3L: add CSI1 device node
  ARM: dts: sun8i: V3/V3s/S3/S3L: add pinctrl for 8-bit parallel CSI
  ARM: dts: sun8i: V3/V3s/S3/S3L: add pinctrl for I2C1 at PE bank
  dt-bindings: arm: sunxi: add Pine64 PineCube binding
  ARM: dts: sun8i: s3l: add support for Pine64 PineCube IP camera

 .../devicetree/bindings/arm/sunxi.yaml        |   5 +
 arch/arm/boot/dts/Makefile                    |   1 +
 arch/arm/boot/dts/sun8i-s3-pinecube.dts       | 235 ++++++++++++++++++
 arch/arm/boot/dts/sun8i-v3.dtsi               |  13 +
 arch/arm/boot/dts/sun8i-v3s.dtsi              |  91 +++++++
 5 files changed, 345 insertions(+)
 create mode 100644 arch/arm/boot/dts/sun8i-s3-pinecube.dts

-- 
2.27.0