[PATCH] Bluetooth: btusb: Avoid unnecessary reset upon system resume

[Kai-Heng Feng]

Realtek bluetooth controller may fail to work after system sleep:
[ 1272.707670] Bluetooth: hci0: command 0x1001 tx timeout
[ 1280.835712] Bluetooth: hci0: RTL: HCI_OP_READ_LOCAL_VERSION failed (-110)

If platform firmware doesn't cut power off during suspend, the firmware
is considered retained in controller but the driver is still asking USB
core to perform a reset-resume. This can make bluetooth controller
unusable.

So avoid unnecessary reset to resolve the issue.

For devices that really lose power during suspend, USB core will detect
and handle reset-resume correctly.

Signed-off-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx>
---
 drivers/bluetooth/btusb.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 8d2608ddfd08..de86ef4388f9 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -4255,17 +4255,15 @@ static int btusb_suspend(struct usb_interface *intf, pm_message_t message)
 		enable_irq(data->oob_wake_irq);
 	}
 
-	/* For global suspend, Realtek devices lose the loaded fw
-	 * in them. But for autosuspend, firmware should remain.
-	 * Actually, it depends on whether the usb host sends
+	/* For global suspend, Realtek devices lose the loaded fw in them if
+	 * platform firmware cut power off. But for autosuspend, firmware
+	 * should remain.  Actually, it depends on whether the usb host sends
 	 * set feature (enable wakeup) or not.
 	 */
 	if (test_bit(BTUSB_WAKEUP_DISABLE, &data->flags)) {
 		if (PMSG_IS_AUTO(message) &&
 		    device_can_wakeup(&data->udev->dev))
 			data->udev->do_remote_wakeup = 1;
-		else if (!PMSG_IS_AUTO(message))
-			data->udev->reset_resume = 1;
 	}
 
 	return 0;
-- 
2.17.1