[PATCH 5.8 21/56] net: phy: call phy_disable_interrupts() in phy_attach_direct() instead

[Greg Kroah-Hartman]

From: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>

[ Upstream commit 7d3ba9360c6dac7c077fbd6631e08f32ea2bcd53 ]

Since the micrel phy driver calls phy_init_hw() as a workaround,
the commit 9886a4dbd2aa ("net: phy: call phy_disable_interrupts()
in phy_init_hw()") disables the interrupt unexpectedly. So,
call phy_disable_interrupts() in phy_attach_direct() instead.
Otherwise, the phy cannot link up after the ethernet cable was
disconnected.

Note that other drivers (like at803x.c) also calls phy_init_hw().
So, perhaps, the driver caused a similar issue too.

Fixes: 9886a4dbd2aa ("net: phy: call phy_disable_interrupts() in phy_init_hw()")
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/net/phy/phy_device.c |    8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -1092,10 +1092,6 @@ int phy_init_hw(struct phy_device *phyde
 	if (ret < 0)
 		return ret;
 
-	ret = phy_disable_interrupts(phydev);
-	if (ret)
-		return ret;
-
 	if (phydev->drv->config_init)
 		ret = phydev->drv->config_init(phydev);
 
@@ -1372,6 +1368,10 @@ int phy_attach_direct(struct net_device
 	if (err)
 		goto error;
 
+	err = phy_disable_interrupts(phydev);
+	if (err)
+		return err;
+
 	phy_resume(phydev);
 	phy_led_triggers_register(phydev);