[PATCH v6 6/6] irqchip: qcom-pdc: Reset PDC interrupts during init

[Maulik Shah]

Kexec can directly boot into a new kernel without going to complete
reboot. This can leave the previous kernel's configuration for PDC
interrupts as is.

Clear previous kernel's configuration during init by setting interrupts
in enable bank to zero. The IRQs specified in qcom,pdc-ranges property
are the only ones that can be used by the new kernel so clear only those
IRQs. The remaining ones may be in use by a different kernel and should
not be set by new kernel.

Acked-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
Suggested-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Signed-off-by: Maulik Shah <mkshah@xxxxxxxxxxxxxx>
---
 drivers/irqchip/qcom-pdc.c | 11 ++++++++++-
 1 file changed, 10 insertions(+), 1 deletion(-)

diff --git a/drivers/irqchip/qcom-pdc.c b/drivers/irqchip/qcom-pdc.c
index acc0620..bd39e9d 100644
--- a/drivers/irqchip/qcom-pdc.c
+++ b/drivers/irqchip/qcom-pdc.c
@@ -341,7 +341,8 @@ static const struct irq_domain_ops qcom_pdc_gpio_ops = {
 
 static int pdc_setup_pin_mapping(struct device_node *np)
 {
-	int ret, n;
+	int ret, n, i;
+	u32 irq_index, reg_index, val;
 
 	n = of_property_count_elems_of_size(np, "qcom,pdc-ranges", sizeof(u32));
 	if (n <= 0 || n % 3)
@@ -370,6 +371,14 @@ static int pdc_setup_pin_mapping(struct device_node *np)
 						 &pdc_region[n].cnt);
 		if (ret)
 			return ret;
+
+		for (i = 0; i < pdc_region[n].cnt; i++) {
+			reg_index = (i + pdc_region[n].pin_base) >> 5;
+			irq_index = (i + pdc_region[n].pin_base) & 0x1f;
+			val = pdc_reg_read(IRQ_ENABLE_BANK, reg_index);
+			val &= ~BIT(irq_index);
+			pdc_reg_write(IRQ_ENABLE_BANK, reg_index, val);
+		}
 	}
 
 	return 0;
-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation