Re: [PATCH v2 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board

[Neil Armstrong]

Hi Felipe,

Is there anything to change in this serie ?

Thanks,
Neil

On 17/09/2020 08:59, Neil Armstrong wrote:
> The Amlogic AXG is close to the GXL Glue but with a single OTG PHY.
> 
> It needs the same init sequence as GXL & GXM, but it seems it doesn't need
> the host disconnect bit.
> 
> The Glue driver reuses the already implemented GXL & GXM work.
> 
> The USB2 PHY driver needs a slight tweak to keep the OTG detection working.
> 
> Changes since v1 at [1]:
> - s/close from/close to/g
> - collected review tags
> - added small comment about phy management in patch 3
> - removed status = "okay" in patch 4
> - removed invalid phy-supply of phy1 in patch 5
> 
> [1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@xxxxxxxxxxxx
> 
> Neil Armstrong (5):
>   phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
>   dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
>     Families USB Glue Bindings
>   usb: dwc-meson-g12a: Add support for USB on AXG SoCs
>   arm64: dts: meson-axg: add USB nodes
>   arm64: dts: meson-axg-s400: enable USB OTG
> 
>  .../usb/amlogic,meson-g12a-usb-ctrl.yaml      | 22 +++++++-
>  .../arm64/boot/dts/amlogic/meson-axg-s400.dts |  6 +++
>  arch/arm64/boot/dts/amlogic/meson-axg.dtsi    | 50 +++++++++++++++++++
>  drivers/phy/amlogic/phy-meson-gxl-usb2.c      |  3 +-
>  drivers/usb/dwc3/dwc3-meson-g12a.c            | 18 +++++++
>  5 files changed, 97 insertions(+), 2 deletions(-)
>