RE: How to use an ACPI declared GPIO in a userspace ...

[Flavio Suligoi]

Hi Andy,

> > > > > I was wondering if there is a generic GPIO driver that I can use
> Maybe I was not so clear, but as Bart mentioned the least you can do
> is simply define line name via "gpio-line-names" property. The problem
> here is when and how you would like to have them incorporated.

I already tried adding the "gpio-line-names" property, but the problem
is the same: no driver asks for this GPIO, as shown by the following
kernel messages:

ACPI: Host-directed Dynamic ACPI Table Load:
ACPI: SSDT 0xFFFF994034D42A00 0000E8 (v05 ASEMsp GPIO_BTN 00000001 INTL 20200717)
ACPI: \_SB_.GPO1.BTNS: PRP0001 requires 'compatible' property

So I'll start to write a simple device driver to use this GPIO.
I'll keep you informed!
 
> When: if ACPI tables are being provided by firmware which you may not
> alter, then you must use initramfs type of solution (no configfs,
> don't know about EFI var though). How: In that case you might have a
> chance to incorporate _DSD() method into *existing* _CRS() one.
> Possible impediments: if ACPI table from firmware already has a _DSD()
> defined or above is not working for some reason. In such a case you
> must upgrade entire DSDT via initramfs.
> 
> > > > Adding Andy who knows ACPI GPIO well.
> > >
> > > Thanks.
> > >
> > > > In general, the "gpio-line-names" property is used for that and it's
> > > > supported both for device tree as well as ACPI, although I have only
> > > > ever used the former.
> > >
> > > Right. ACPI supports properties via _DSD() method.
> 
> --
> With Best Regards,
> Andy Shevchenko

Thanks Andy and Bartosz for your support!
Best regards,

Flavio