Re: [PATCH v3 7/9] spi: spi-s3c64xx: Ensure cur_speed holds actual clock value

[Krzysztof Kozlowski]

On Fri, Oct 02, 2020 at 02:22:41PM +0200, Łukasz Stelmach wrote:
> Make sure the cur_speed value used in s3c64xx_enable_datapath()
> to configure DMA channel and in s3c64xx_wait_for_*() to calculate the
> transfer timeout is set to the actual value of (half) the clock speed.
> 
> Don't change non-CMU case, because no frequency calculation errors have
> been reported.
> 
> Reviewed-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> Suggested-by: Tomasz Figa <tomasz.figa@xxxxxxxxx>
> Signed-off-by: Łukasz Stelmach <l.stelmach@xxxxxxxxxxx>

For the future, tags are added in chronological order, so first is
suggested (as someone suggested to make a patch), then your SoB (as you
wrote it) and then my review (because you had to write a patch before I
could review).

All other patches here have these mixed up. No need to resend, but keep
it in mind for the future.

Best regards,
Krzysztof