Re: [PATCH 2/3] venus: vdec: Make decoder return LAST flag for sufficient event

[vgarodia]

Hi Stan,

On 2020-09-28 22:14, Stanimir Varbanov wrote:
> This makes the decoder to behaives equally for sufficient and
behaves

> insufficient events. After this change the LAST buffer flag will be set
> when the new resolution (in dynamic-resolution-change state) is smaller
> then the old bitstream resolution.
>
> Signed-off-by: Stanimir Varbanov <stanimir.varbanov@xxxxxxxxxx>
> ---
>  drivers/media/platform/qcom/venus/vdec.c | 41 ++++++++++++++++--------
>  1 file changed, 27 insertions(+), 14 deletions(-)
>
> diff --git a/drivers/media/platform/qcom/venus/vdec.c
> b/drivers/media/platform/qcom/venus/vdec.c
> index c11bdf3ca21b..c006401255dc 100644
> --- a/drivers/media/platform/qcom/venus/vdec.c
> +++ b/drivers/media/platform/qcom/venus/vdec.c
> @@ -634,6 +634,7 @@ static int vdec_output_conf(struct venus_inst 
> *inst)
>  {
>  	struct venus_core *core = inst->core;
>  	struct hfi_enable en = { .enable = 1 };
> +	struct hfi_buffer_requirements bufreq;
>  	u32 width = inst->out_width;
>  	u32 height = inst->out_height;
>  	u32 out_fmt, out2_fmt;
> @@ -709,6 +710,22 @@ static int vdec_output_conf(struct venus_inst 
> *inst)
>  	}
>
>  	if (IS_V3(core) || IS_V4(core)) {
> +		ret = venus_helper_get_bufreq(inst, HFI_BUFFER_OUTPUT, &bufreq);
> +		if (ret)
> +			return ret;
> +
> +		if (bufreq.size > inst->output_buf_size)
> +			return -EINVAL;
> +
> +		if (inst->dpb_fmt) {
> +			ret = venus_helper_get_bufreq(inst, HFI_BUFFER_OUTPUT2, &bufreq);
> +			if (ret)
> +				return ret;
> +
> +			if (bufreq.size > inst->output2_buf_size)
> +				return -EINVAL;
> +		}
> +
>  		if (inst->output2_buf_size) {
>  			ret = venus_helper_set_bufsize(inst,
>  						       inst->output2_buf_size,
> @@ -1327,19 +1344,15 @@ static void vdec_event_change(struct venus_inst 
> *inst,
>  	dev_dbg(dev, VDBGM "event %s sufficient resources (%ux%u)\n",
>  		sufficient ? "" : "not", ev_data->width, ev_data->height);
>
> -	if (sufficient) {
> -		hfi_session_continue(inst);
> -	} else {
> -		switch (inst->codec_state) {
> -		case VENUS_DEC_STATE_INIT:
> -			inst->codec_state = VENUS_DEC_STATE_CAPTURE_SETUP;
> -			break;
> -		case VENUS_DEC_STATE_DECODING:
> -			inst->codec_state = VENUS_DEC_STATE_DRC;
> -			break;
> -		default:
> -			break;
> -		}
> +	switch (inst->codec_state) {
> +	case VENUS_DEC_STATE_INIT:
> +		inst->codec_state = VENUS_DEC_STATE_CAPTURE_SETUP;
> +		break;
> +	case VENUS_DEC_STATE_DECODING:
> +		inst->codec_state = VENUS_DEC_STATE_DRC;

Video firmware would raise reconfig event to driver even for cases like
interlace detection, color space change in the bitstream. If not with 
this patch,
we can optimize by sending reconfig event only for resolution and 
bitdepth update,
in a followup patch.

> +		break;
> +	default:
> +		break;
>  	}
>
>  	/*
> @@ -1348,7 +1361,7 @@ static void vdec_event_change(struct venus_inst 
> *inst,
>  	 * itself doesn't mark the last decoder output buffer with HFI EOS 
> flag.
>  	 */
>
> -	if (!sufficient && inst->codec_state == VENUS_DEC_STATE_DRC) {
> +	if (inst->codec_state == VENUS_DEC_STATE_DRC) {
>  		struct vb2_v4l2_buffer *last;
>  		int ret;