[PATCH 1/2] dt-bindings: powerpc: Add a schema for the 'sleep' property

From: Rob Herring
Date: Thu Oct 08 2020 - 10:24:28 EST


Document the PowerPC specific 'sleep' property as a schema. It is
currently only documented in booting-without-of.rst which is getting
removed.

Cc: Michael Ellerman <mpe@xxxxxxxxxxxxxx>
Cc: Benjamin Herrenschmidt <benh@xxxxxxxxxxxxxxxxxxx>
Cc: Paul Mackerras <paulus@xxxxxxxxx>
Cc: linuxppc-dev@xxxxxxxxxxxxxxxx
Signed-off-by: Rob Herring <robh@xxxxxxxxxx>
---
.../devicetree/bindings/powerpc/sleep.yaml | 47 +++++++++++++++++++
1 file changed, 47 insertions(+)
create mode 100644 Documentation/devicetree/bindings/powerpc/sleep.yaml

diff --git a/Documentation/devicetree/bindings/powerpc/sleep.yaml b/Documentation/devicetree/bindings/powerpc/sleep.yaml
new file mode 100644
index 000000000000..6494c7d08b93
--- /dev/null
+++ b/Documentation/devicetree/bindings/powerpc/sleep.yaml
@@ -0,0 +1,47 @@
+# SPDX-License-Identifier: GPL-2.0-only
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/powerpc/sleep.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: PowerPC sleep property
+
+maintainers:
+ - Rob Herring <robh@xxxxxxxxxx>
+
+description: |
+ Devices on SOCs often have mechanisms for placing devices into low-power
+ states that are decoupled from the devices' own register blocks. Sometimes,
+ this information is more complicated than a cell-index property can
+ reasonably describe. Thus, each device controlled in such a manner
+ may contain a "sleep" property which describes these connections.
+
+ The sleep property consists of one or more sleep resources, each of
+ which consists of a phandle to a sleep controller, followed by a
+ controller-specific sleep specifier of zero or more cells.
+
+ The semantics of what type of low power modes are possible are defined
+ by the sleep controller. Some examples of the types of low power modes
+ that may be supported are:
+
+ - Dynamic: The device may be disabled or enabled at any time.
+ - System Suspend: The device may request to be disabled or remain
+ awake during system suspend, but will not be disabled until then.
+ - Permanent: The device is disabled permanently (until the next hard
+ reset).
+
+ Some devices may share a clock domain with each other, such that they should
+ only be suspended when none of the devices are in use. Where reasonable,
+ such nodes should be placed on a virtual bus, where the bus has the sleep
+ property. If the clock domain is shared among devices that cannot be
+ reasonably grouped in this manner, then create a virtual sleep controller
+ (similar to an interrupt nexus, except that defining a standardized
+ sleep-map should wait until its necessity is demonstrated).
+
+select: true
+
+properties:
+ sleep:
+ $ref: /schemas/types.yaml#definitions/phandle-array
+
+additionalProperties: true
--
2.25.1