Re: [Nouveau] nouveau broken on Riva TNT2 in 5.9.0-rc8: GPU not supported on big-endian

[Karol Herbst]

On Sat, Oct 10, 2020 at 12:23 AM Ilia Mirkin <imirkin@xxxxxxxxxxxx> wrote:
>
> On Fri, Oct 9, 2020 at 5:54 PM Karol Herbst <kherbst@xxxxxxxxxx> wrote:
> >
> > On Fri, Oct 9, 2020 at 11:35 PM Ondrej Zary <linux@xxxxxxx> wrote:
> > >
> > > Hello,
> > > I'm testing 5.9.0-rc8 and found that Riva TNT2 stopped working:
> > > [    0.000000] Linux version 5.9.0-rc8+ (zary@gsql) (gcc (Debian 8.3.0-6) 8.3.0, GNU ld (GNU Binutils for Debian) 2.31.1) #326 SMP Fri Oct 9 22:31:40 CEST 2020
> > > ...
> > > [   14.771464] nouveau 0000:01:00.0: GPU not supported on big-endian
> > > [   14.771782] nouveau: probe of 0000:01:00.0 failed with error -38
> > >
> > > big-endian? WTF? The machine is x86.
> > >
> >
> > mhh, we reworked the endianess checks a bit and apparently that broke
> > something... I will give it some thoughts, but could you be so kind
> > and create an mmiotrace under 5.9 with nouveau? You won't need to
> > start X or anything while doing it. Just enable the trace and modprobe
> > nouveau and collect the trace.
>
> Looks like nvkm_device_endianness unconditionally reads out 0x4. I
> don't think that reg is there pre-NV11. At least NV4, NV5, NV10 and
> maybe NV15 (which is logically pre-NV11) don't support big-endian
> mode. Not sure about NV1A, which was the IGP of the series and IIRC
> logically pre-NV11 as well (but clearly could only be used with x86
> chips, since it was part of the motherboard).
>
> Aha, it's documented in rnndb:
>
> https://github.com/envytools/envytools/blob/master/rnndb/bus/pmc.xml
> <reg32 offset="0x004" name="ENDIAN" variants="NV1A-"/>
>

ohh, I should have checked there.. yeah, will write a fix for it then.
Before my patch we just always tried to switch it, but never threw an
error.

>   -ilia
>