Re: Dts for eth network based on marvell's mv88e6390x crashes Xilinx's linux-kernel v5.4

[Andrew Lunn]

On Mon, Oct 19, 2020 at 05:05:08PM +0300, michael alayev wrote:
> Hello Andrew,
> 
> 
>     > Please fix your email client and
> 
> 
>     > post the DT file for review. I will
> 
>     > then point out some of the errors.
> 
> 
> 
>     &gem0 {
>         status = "okay";
>         phy-mode = "rgmii-id";
>         phy-handle = <&phy0>;

The diagram you showed had gem0 connected directly to the switch. So
this phy-handle is wrong. Or the diagram is wrong.

> 
>         mdio {
>             #address-cells = <1>;
>             #size-cells = <0>;
> 
>             phy0: ethernet-phy@0 {
>                 compatible = "marvell";
>                 reg = <0>;
>                 device_type = "ethernet-phy";
>                 fixed-link {
>                     speed = <1000>;
>                     full-duplex;
>                 };
>             };
> 
>             debug_phy: ethernet-phy@1 {
>             compatible = "marvell";
>             reg = <1>;
>             device_type = "ethernet-phy";
>             label = "debug-phy";
>         };

indentation is all wrong here.

>         switch0: switch@2 {
>             compatible = "marvell,mv88e6190";
>             #address-cells = <1>;
>             #size-cells = <0>;
>             reg = <2>;
> 
>             dsa,member = <0 0>;
> 
>             ports {
>                 #address-cells = <1>;
>                 #size-cells = <0>;
> 
>                 switch0phy1: port@0 {
>                     reg = <0>;
>                     label = "uid208-cpu";
>                     ethernet = <&gem0>;
>                     phy-mode = "rgmii-id";

You have gem0 using gphy-mode = "rgmii-id" as well. Both doing delays
will not work. You should drop the one in gem0.

>                     fixed-link {
>                         speed = <1000>;
>                         full-duplex;
>                     };
>                 };
> 
> 
>                 port@1 {
>                     reg = <1>;
>                     label = "uid201-1A";
>                 };
> 
>                 port@2 {
>                     reg = <2>;
>                     label = "uid202-2A-p9-1A";
>                     phy-mode = "1000base-x";
>                     fixed-link {
>                         speed = <1000>;
>                         full-duplex;
>                     };

Why both 1000base-x and fixed link? Do you have an SFP connected? If
so, describe the SFP in DT.

>                 };
> 
>                 switch0port10: port@10 {
>                     reg = <10>;
>                     label = "dsa";
>                     link = <&switch1port10>;
>                     phy-mode = "1000base-x";
>                     fixed-link {
>                         speed = <1000>;
>                         full-duplex;
>                     };
>                 };

This is a 6390X right? Why limit it to 1000base-X when it could be
doing 10G?

      Andrew