Re: [PATCH] x86/build: Fix vmlinux size check on 64-bit
From: Borislav Petkov
Date: Wed Oct 28 2020 - 17:56:31 EST
On Tue, Oct 27, 2020 at 05:14:22PM -0400, Arvind Sankar wrote:
> This is indeed just a small correctness fixlet, but I'm not following
> the rest of your comments.
I'm just trying to make sense of that house of cards we have here.
> PHYSICAL_START has an effect independent of the setting of
> RELOCATABLE.
Theoretically you can set PHYSICAL_START to 0x0:
config PHYSICAL_START
hex "Physical address where the kernel is loaded" if (EXPERT || CRASH_DUMP)
default "0x1000000"
help
This gives the physical address where the kernel is loaded.
If kernel is a not relocatable (CONFIG_RELOCATABLE=n) then
bzImage will decompress itself to above physical address and
run from there.
^^^^^^^^^^^^^^
and disable RELOCATABLE:
CONFIG_PHYSICAL_START=0x0
# CONFIG_RELOCATABLE is not set
but then you hit this:
ld: per-CPU data too large - increase CONFIG_PHYSICAL_START
full output at the end of the mail.
> It's where the kernel image starts in virtual address space, as shown
> by the 16MiB difference between __START_KERNEL_map and _text in the
> usual .config situation. In all configs, not just majority, the kernel
> image itself starts at _text.
Of course.
> The 16MiB gap below _text is not actually mapped, but the important
> point is that the way the initial construction of pagetables is
> currently setup, the code cannot map anything above __START_KERNEL_map
> + KERNEL_IMAGE_SIZE, so _end needs to be below that.
Right.
> If KASLR was disabled (either at build-time or run-time), these
> link-time addresses are where the kernel actually lives (in VA space);
> and if it was enabled, it will make sure to place the _end of the kernel
> below KERNEL_IMAGE_SIZE when choosing a random virtual location.
Yes.
> That said, AFAICT, RELOCATABLE and PHYSICAL_START look like historical
> artifacts at this point: RELOCATABLE should be completely irrelevant for
> the 64-bit kernel, and there's really no reason to be able to configure
> the start VA of the kernel, that should just be constant independent of
> PHYSICAL_START.
See the CONFIG_PHYSICAL_START help text. Apparently there has been a
use case where one can set PHYSICAL_START to the region where a kdump
kernel is going to be loaded and that kdump kernel is a vmlinux and not
a bzImage and thus not relocatable.
And I just produced a .config which doesn't work. I guess
"Don't change this unless you know what you are doing."
is supposed to say that that value can't be just anything but that ain't
good enough.
Lemme try a different offset after reading this:
Otherwise if you plan to use vmlinux
for capturing the crash dump change this value to start of
the reserved region. In other words, it can be set based on
the "X" value as specified in the "crashkernel=YM@XM"
Setting it to 256M works:
$ readelf -a vmlinux | grep -E "\W(_end|_text)"
95509: ffffffff90000000 0 NOTYPE GLOBAL DEFAULT 1 _text
97868: ffffffff9aa26000 0 NOTYPE GLOBAL DEFAULT 30 _end
Setting to 8M works too, it seems:
$ readelf -a vmlinux | grep -E "\W(_end|_text)"
95509: ffffffff80800000 0 NOTYPE GLOBAL DEFAULT 1 _text
97868: ffffffff8b226000 0 NOTYPE GLOBAL DEFAULT 30 _end
so I guess this should be a range > 0 specification but I guess not
important.
Going back to the question at hand, if you think about it, the kernel
image *is* between _text or _stext and _end. And KERNEL_IMAGE_SIZE is
exactly what it is - the size of the kernel image.
Now, if you were talking about a kernel *mapping* size, then I'd
understand but this check is for the kernel *image* size.
But reading that commit message again:
these build-time and link-time checks would have prevented the
vmlinux size regression.
this *is* talking about vmlinux size and that starts at _text...
Thx.
ld: per-CPU data too large - increase CONFIG_PHYSICAL_START
init/main.o: in function `perf_trace_initcall_level':
/home/boris/kernel/linux/./include/trace/events/initcall.h:10:(.text+0x147): relocation truncated to fit: R_X86_64_PC32 against symbol `this_cpu_off' defined in .data..percpu..read_mostly section in arch/x86/kernel/setup_percpu.o
init/main.o: in function `perf_trace_initcall_start':
/home/boris/kernel/linux/./include/trace/events/initcall.h:27:(.text+0x252): relocation truncated to fit: R_X86_64_PC32 against symbol `this_cpu_off' defined in .data..percpu..read_mostly section in arch/x86/kernel/setup_percpu.o
init/main.o: in function `perf_trace_initcall_finish':
/home/boris/kernel/linux/./include/trace/events/initcall.h:48:(.text+0x319): relocation truncated to fit: R_X86_64_PC32 against symbol `this_cpu_off' defined in .data..percpu..read_mostly section in arch/x86/kernel/setup_percpu.o
init/main.o: in function `preempt_count':
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:26:(.text+0x823): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:26:(.text+0x84f): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
init/main.o: in function `preempt_count_set':
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:34:(.text+0x88f): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:37:(.text+0x8a3): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
init/main.o: in function `trace_initcall_start':
/home/boris/kernel/linux/./include/trace/events/initcall.h:27:(.text+0x8e5): relocation truncated to fit: R_X86_64_PC32 against symbol `cpu_number' defined in .data..percpu..read_mostly section in arch/x86/kernel/setup_percpu.o
init/main.o: in function `__preempt_count_add':
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:79:(.text+0x8fc): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
init/main.o: in function `__preempt_count_dec_and_test':
/home/boris/kernel/linux/./arch/x86/include/asm/preempt.h:94:(.text+0x91b): relocation truncated to fit: R_X86_64_PC32 against symbol `__preempt_count' defined in .data..percpu section in arch/x86/kernel/cpu/common.o
init/main.o: in function `trace_initcall_finish':
/home/boris/kernel/linux/./include/trace/events/initcall.h:48:(.text+0x932): additional relocation overflows omitted from the output
make: *** [Makefile:1164: vmlinux] Error 1
--
Regards/Gruss,
Boris.
https://people.kernel.org/tglx/notes-about-netiquette