[RFC PATCH 0/3] mwifiex: add fw reset quirks for Microsoft Surface

[Tsuchiya Yuto]

Hello all,

This series adds firmware reset quirks for Microsoft Surface devices
(PCIe-88W8897). Surface devices somehow requires quirks to reset the
firmware. Otherwise, current mwifiex driver can reset only software level.
This is not enough to recover from a bad state.

To do so, in the first patch, I added a DMI-based quirk implementation
for Surface devices that use mwifiex chip.

The required quirk is different by generation. Surface gen3 devices
(Surface 3 and Surface Pro 3) require a quirk that calls _DSM method
(the third patch).
Note that Surface Pro 3 is not yet supported because of the difference
between Surface 3. On Surface 3, the wifi card will be immediately
removed/reprobed after the _DSM call. On the other hand, Surface Pro 3
doesn't. Need to remove/reprobe wifi card ourselves. This behavior makes
the support difficult.

Surface gen4+ devices (Surface Pro 4 and later) require a quirk that
puts wifi into D3cold before FLR.

While here, created new files for quirks (mwifiex/pcie_quirks.c and
mwifiex/pcie_quirks.h) because the changes are a little bit too big to
add into pcie.c.

Thanks,
Tsuchiya Yuto

Tsuchiya Yuto (3):
  mwifiex: pcie: add DMI-based quirk impl for Surface devices
  mwifiex: pcie: add reset_d3cold quirk for Surface gen4+ devices
  mwifiex: pcie: add reset_wsid quirk for Surface 3

 drivers/net/wireless/marvell/mwifiex/Makefile |   1 +
 drivers/net/wireless/marvell/mwifiex/pcie.c   |  21 ++
 drivers/net/wireless/marvell/mwifiex/pcie.h   |   2 +
 .../wireless/marvell/mwifiex/pcie_quirks.c    | 246 ++++++++++++++++++
 .../wireless/marvell/mwifiex/pcie_quirks.h    |  17 ++
 5 files changed, 287 insertions(+)
 create mode 100644 drivers/net/wireless/marvell/mwifiex/pcie_quirks.c
 create mode 100644 drivers/net/wireless/marvell/mwifiex/pcie_quirks.h

-- 
2.29.1