[PATCH 0/5] Elimo Impetus and Initium support

[Matteo Scordino]

The Elimo Impetus is an Open Source Hardware System-on-Module based on the 
SoChip S3 SoC.
It is meant for integration into carrier boards or, more generally, larger 
designs, and uses an M2 connector to facilitate that.
The Elimo Initium is a carrier board for the Impetus, together they provide a 
fully open source SBC.

This patch set adds support for both. It it based off the sunxi/dt-for-5.11
branch of the https://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux.git
tree.

Matteo Scordino (5):
  dt-bindings: vendors: add Elimo Engineering vendor prefix
  ARM: dts: sun8i: V3/S3: Add UART1 pin definitions to the V3/S3 dtsi
  ARM: dts: sun8i: s3: Add dtsi for the Elimo Impetus SoM
  dt-bindings: arm: sunxi: add Elimo bindings
  ARM: dts: sun8i: s3: Add dts for the Elimo Initium SBC

 .../devicetree/bindings/arm/sunxi.yaml        | 10 ++++
 .../devicetree/bindings/vendor-prefixes.yaml  |  2 +
 arch/arm/boot/dts/Makefile                    |  1 +
 arch/arm/boot/dts/sun8i-s3-elimo-impetus.dtsi | 51 +++++++++++++++++++
 arch/arm/boot/dts/sun8i-s3-elimo-initium.dts  | 27 ++++++++++
 arch/arm/boot/dts/sun8i-v3.dtsi               |  5 ++
 6 files changed, 96 insertions(+)
 create mode 100644 arch/arm/boot/dts/sun8i-s3-elimo-impetus.dtsi
 create mode 100644 arch/arm/boot/dts/sun8i-s3-elimo-initium.dts

-- 
2.20.1