RE: [PATCH V4 0/6] can: flexcan: add stop mode support for i.MX8QM

[Joakim Zhang]

Gentle Ping...

@shawnguo@xxxxxxxxxx, Could you please help review patch 1/6 and 5/6 in this patch set?

Best Regards,
Joakim Zhang

> -----Original Message-----
> From: Joakim Zhang <qiangqing.zhang@xxxxxxx>
> Sent: 2020年10月21日 13:33
> To: mkl@xxxxxxxxxxxxxx; robh+dt@xxxxxxxxxx; shawnguo@xxxxxxxxxx;
> s.hauer@xxxxxxxxxxxxxx
> Cc: kernel@xxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>; Ying Liu
> <victor.liu@xxxxxxx>; linux-can@xxxxxxxxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
> linux-kernel@xxxxxxxxxxxxxxx
> Subject: RE: [PATCH V4 0/6] can: flexcan: add stop mode support for i.MX8QM
> 
> 
> > -----Original Message-----
> > From: Joakim Zhang <qiangqing.zhang@xxxxxxx>
> > Sent: 2020年10月21日 13:25
> > To: mkl@xxxxxxxxxxxxxx; robh+dt@xxxxxxxxxx; shawnguo@xxxxxxxxxx;
> > s.hauer@xxxxxxxxxxxxxx
> > Cc: kernel@xxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>; Ying Liu
> > <victor.liu@xxxxxxx>; linux-can@xxxxxxxxxxxxxxx;
> > netdev@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> > Subject: [PATCH V4 0/6] can: flexcan: add stop mode support for
> > i.MX8QM
> >
> > The first patch from Liu Ying aims to export SCU symbols for SoCs w/wo
> > SCU, so that no need to check CONFIG_IMX_SCU in the specific driver.
> >
> > The following patches are flexcan fixes and add stop mode support for
> > i.MX8QM.
> 
> Hi Shawnguo,
> 
> Could you please help review patch 1/6 and 5/6? Since flexcan driver depends
> on these. Thanks.
> 
> For patch 1/6, it will benefit other drivers which cover SoCs w/wo SCU, such as
> i.MX Ethernet Controller driver (drivers/net/ethernet/freescale/fec_main.c).
> 
> Best Regards,
> Joakim Zhang