Re: [PATCH 1/3] Input: goodix - add option to disable firmware loading

[Hans de Goede]

Hi,

On 10/29/20 9:36 PM, Dmitry Torokhov wrote:
> Hi Andrej,
> 
> On Thu, Oct 29, 2020 at 06:03:11PM +0100, Andrej Valek wrote:
>> Firmware file loadind for GT911 controller takes too much time (~60s).
>> There is no check that configuration is the same which is already present.
>> This happens always during boot, which makes touchscreen unusable.
>>
>> Add there an option to prevent firmware file loading, but keep it enabled
>> by default.
> 
> I thought that Goodix was losing firmware loading at poweroff. Is this
> not the case with this model?

So first of all there are 2 sorts of firmware involved with the
Goodix touchscreen controllers, the actual firmware and a block
of config data for that firmware which I presume adjusts it for
the specific (model of) the digitizer which is attached.

ATM the mainline Linux driver does not support models where
the actual firmware itself needs to be loaded (because they
only have RAM, so they come up without firmware).

I do have one model tablet with a ROM-less goodix touchpad
controller, so if I ever find the time I might add support
for loading the actual firmware.

So what we are talking about here is just loading the config
data and I'm a bit surprised that this take so long.

> Adding Hans as he was working with this driver/code.

With all that said I have no objection to this change.

Regards,

Hans



> 
>>
>> Signed-off-by: Andrej Valek <andrej.valek@xxxxxxxxxxx>
>> ---
>>  drivers/input/touchscreen/goodix.c | 4 +++-
>>  1 file changed, 3 insertions(+), 1 deletion(-)
>>
>> diff --git a/drivers/input/touchscreen/goodix.c b/drivers/input/touchscreen/goodix.c
>> index 02c75ea385e08..44336ecd2acdf 100644
>> --- a/drivers/input/touchscreen/goodix.c
>> +++ b/drivers/input/touchscreen/goodix.c
>> @@ -941,7 +941,9 @@ static int goodix_get_gpio_config(struct goodix_ts_data *ts)
>>  	default:
>>  		if (ts->gpiod_int && ts->gpiod_rst) {
>>  			ts->reset_controller_at_probe = true;
>> -			ts->load_cfg_from_disk = true;
>> +			/* Prevent cfg loading for each start */
>> +			ts->load_cfg_from_disk = !device_property_read_bool(dev,
>> +						 "touchscreen-do-not-load-fw");
>>  			ts->irq_pin_access_method = IRQ_PIN_ACCESS_GPIO;
>>  		}
>>  	}
>> -- 
>> 2.20.1
>>
> 
> Thanks.
>