Re: [PATCH net-next v3 2/4] dt-bindings: net: Add Rx/Tx output configuration for 10base T1L

[Dan Murphy]

Andrew

On 10/30/20 2:56 PM, Andrew Lunn wrote:
> On Fri, Oct 30, 2020 at 12:29:48PM -0500, Dan Murphy wrote:
> > Per the 802.3cg spec the 10base T1L can operate at 2 different
> > differential voltages 1v p2p and 2.4v p2p. The abiility of the PHY to
> > drive that output is dependent on the PHY's on board power supply.
> Hi Dan
>
> So this property is about the board being able to support the needed
> voltages? The PHY is not forced into 2.4v p2p, it just says the PHY
> can operate at 2.4v and the board will not melt, blow a fuse, etc?
>
> I actually think it is normal to specify the reverse. List the maximum
> that device can do because of board restrictions. e.g.
>
> - maximum-power-milliwatt : Maximum module power consumption
>    Specifies the maximum power consumption allowable by a module in the
>    slot, in milli-Watts.  Presently, modules can be up to 1W, 1.5W or 2W.
>
> - max-link-speed:
>     If present this property specifies PCI gen for link capability.  Host
>     drivers could add this as a strategy to avoid unnecessary operation for
>     unsupported link speed, for instance, trying to do training for
>     unsupported link speed, etc.  Must be '4' for gen4, '3' for gen3, '2'
>     for gen2, and '1' for gen1. Any other values are invalid.
>
>   - max-microvolt : The maximum voltage value supplied to the haptic motor.
>                  [The unit of the voltage is a micro]
>
> So i think this property should be
>
>     max-tx-rx-p2p = <1000>;

When I was re-writing the code I couldn't come up with a better property 
name but I like this one.

I will implement it.

Do you have any issue with the property being in the ethernet-phy.yaml?

Dan