Re: [PATCH v4 6/7] gpio: exar: switch to using regmap

[Andy Shevchenko]

On Tue, Nov 10, 2020 at 03:55:51PM +0100, Bartosz Golaszewski wrote:
> From: Bartosz Golaszewski <bgolaszewski@xxxxxxxxxxxx>
> 
> We can simplify the code in gpio-exar by using regmap. This allows us to
> drop the mutex (regmap provides its own locking) and we can also reuse
> regmap's bit operations instead of implementing our own update function.

...

> +static const struct regmap_config exar_regmap_config = {
> +	.name		= "exar-gpio",
> +	.reg_bits	= 16,

As per previous version comment.

Hold on, the registers are 16-bit wide, but their halves are sparsed!
So, I guess 8 and 8 with helpers to get hi and lo parts are essential.


TABLE 5: DEVICE CONFIGURATION REGISTERS SHOWN IN BYTE ALIGNMENT

> +	.val_bits	= 8,
> +};

This is basically represents two banks out of 6 8-bit registers each.


-- 
With Best Regards,
Andy Shevchenko