Re: [PATCH] ath10k: add option for chip-id based BDF selection

[Abhishek Kumar]

Apologies for the delay, was busy so could not work on V2 . I have
started working on V2 patch. Will upload by today/tomorrow.

Abhishek


On Thu, Nov 5, 2020 at 11:11 PM Kalle Valo <kvalo@xxxxxxxxxxxxxx> wrote:
>
> Abhishek Kumar <kuabhs@xxxxxxxxxxxx> wrote:
>
> > In some devices difference in chip-id should be enough to pick
> > the right BDF. Add another support for chip-id based BDF selection.
> > With this new option, ath10k supports 2 fallback options.
> >
> > The board name with chip-id as option looks as follows
> > board name 'bus=snoc,qmi-board-id=ff,qmi-chip-id=320'
> >
> > Signed-off-by: Abhishek Kumar <kuabhs@xxxxxxxxxxxx>
> > Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> > Tested-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> > Tested-by: Abhishek Kumar <kuabhs@xxxxxxxxxxxx>
>
> There were few checkpatch warnings which I fixed:
>
> $ ath10k-check
> drivers/net/wireless/ath/ath10k/core.c:1501: Alignment should match open parenthesis
> drivers/net/wireless/ath/ath10k/core.c:1512: line length of 92 exceeds 90 columns
> drivers/net/wireless/ath/ath10k/core.c:1521: line length of 92 exceeds 90 columns
>
> The first one was also what Doug commented. I also added Tested-on tags,
> thanks for those. The updated patch is in pending branch (soon).
>
> But is this patch ok to take now? I didn't quite get the conclusion of the
> discussion.
>
> --
> https://patchwork.kernel.org/project/linux-wireless/patch/20201020000506.1.Ifbc28707942179f1cefc7491e995814564495270@changeid/
>
> https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
>