Re: [PATCH 3/3] phy: amlogic: meson8b-usb2: fix shared reset control use

[Martin Blumenstingl]

Hi Amjad,

On Fri, Nov 13, 2020 at 1:07 AM Amjad Ouled-Ameur
<aouledameur@xxxxxxxxxxxx> wrote:
[...]
>         ret = clk_prepare_enable(priv->clk_usb);
>         if (ret) {
>                 dev_err(&phy->dev, "Failed to enable USB DDR clock\n");
> +               reset_control_rearm(priv->reset);
this should come after reset_control_rearm so we're cleaning up in
reverse order of initializing things
(in this case it probably makes no difference since
reset_control_rearm is not touching any registers, but I'd still have
it in the correct order to not confuse future developers)

>                 clk_disable_unprepare(priv->clk_usb_general);
>                 return ret;
>         }
> @@ -197,6 +199,7 @@ static int phy_meson8b_usb2_power_on(struct phy *phy)
>                         regmap_read(priv->regmap, REG_ADP_BC, &reg);
>                         if (reg & REG_ADP_BC_ACA_PIN_FLOAT) {
>                                 dev_warn(&phy->dev, "USB ID detect failed!\n");
> +                               reset_control_rearm(priv->reset);
same here, reset_control_rearm should be after clk_disable_unprepare

>                                 clk_disable_unprepare(priv->clk_usb);
>                                 clk_disable_unprepare(priv->clk_usb_general);
>                                 return -EINVAL;
> @@ -216,6 +219,7 @@ static int phy_meson8b_usb2_power_off(struct phy *phy)
>                                    REG_DBG_UART_SET_IDDQ,
>                                    REG_DBG_UART_SET_IDDQ);
>
> +       reset_control_rearm(priv->reset);
same here, reset_control_rearm should be after clk_disable_unprepare

>         clk_disable_unprepare(priv->clk_usb);
>         clk_disable_unprepare(priv->clk_usb_general);


Best regards,
Martin