[PATCH 1/1] scsi: pm8001: pm8001_hwi: Remove unused variable 'value'

[Lee Jones]

Hasn't been used since 2009.

Fixes the following W=1 kernel build warning(s):

 drivers/scsi/pm8001/pm8001_hwi.c: In function ‘mpi_set_phys_g3_with_ssc’:
 drivers/scsi/pm8001/pm8001_hwi.c:415:6: warning: variable ‘value’ set but not used [-Wunused-but-set-variable]

Cc: Jack Wang <jinpu.wang@xxxxxxxxxxxxxxx>
Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx>
---
 drivers/scsi/pm8001/pm8001_hwi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/pm8001/pm8001_hwi.c b/drivers/scsi/pm8001/pm8001_hwi.c
index 2054c2b03d928..0a1e09b1cd580 100644
--- a/drivers/scsi/pm8001/pm8001_hwi.c
+++ b/drivers/scsi/pm8001/pm8001_hwi.c
@@ -416,7 +416,7 @@ int pm8001_bar4_shift(struct pm8001_hba_info *pm8001_ha, u32 shiftValue)
 static void mpi_set_phys_g3_with_ssc(struct pm8001_hba_info *pm8001_ha,
 				     u32 SSCbit)
 {
-	u32 value, offset, i;
+	u32 offset, i;
 	unsigned long flags;
 
 #define SAS2_SETTINGS_LOCAL_PHY_0_3_SHIFT_ADDR 0x00030000
@@ -467,7 +467,7 @@ static void mpi_set_phys_g3_with_ssc(struct pm8001_hba_info *pm8001_ha,
 	so that the written value will be 0x8090c016.
 	This will ensure only down-spreading SSC is enabled on the SPC.
 	*************************************************************/
-	value = pm8001_cr32(pm8001_ha, 2, 0xd8);
+	pm8001_cr32(pm8001_ha, 2, 0xd8);
 	pm8001_cw32(pm8001_ha, 2, 0xd8, 0x8000C016);
 
 	/*set the shifted destination address to 0x0 to avoid error operation */
-- 
2.25.1