Re: [PATCH] USB: serial: mos7720: defer state restore to a workqueue

[Davidlohr Bueso]

On Mon, 16 Nov 2020, Johan Hovold wrote:

> On Fri, Nov 13, 2020 at 08:27:25PM -0800, Davidlohr Bueso wrote:
> > @@ -1883,21 +1724,17 @@ static void mos7720_release(struct usb_serial *serial)
> > 		if (mos_parport->msg_pending)
> > 			wait_for_completion_timeout(&mos_parport->syncmsg_compl,
> > 					    msecs_to_jiffies(MOS_WDR_TIMEOUT));
> > +		/*
> > +		 * If delayed work is currently scheduled, wait for it to
> > +		 * complete. This also implies barriers that ensure the
> > +		 * below serial clearing is not hoisted above the ->work.
> > +		 */
> > +		cancel_work_sync(&mos_parport->work);
>
> As I mentioned, this needs to be done *after* deregistering the port or
> you could theoretically end up with the work item being requeued.

Hmm sorry yes I forgot to mention this. I was counting on the private_data
already being null to prevent any new work being actually scheduled, so an
incoming restore state, for example, would be a nop.

> Yes, the same applies for the "synchronous" requests, but that's a
> preexisting issue.

Per the above I also assumed sync requests were also safe as is.

But I can certainly re-order things, how about:

mos7720_release():
   mos_parport->pp->private_data = NULL;
   parport_remove_port(mos_parport->pp);

   wait_for_completion_timeout();
   cancel_work_sync();

   usb_set_serial_data(serial, NULL);
   mos_parport->serial = NULL;

   parport_del_port(mos_parport->pp);
   kref_put();

Thanks,
Davidlohr