Re: [PATCH] arm64: dts: ls1028a: make the eMMC and SD card controllers use fixed indices

[Michael Walle]

Hi Vladimir,

Am 2020-11-19 16:50, schrieb Vladimir Oltean:
> As the boot order in the kernel continues to change, sometimes it may
> happen that the eSDHC controller mmc@2150000 (the one for eMMC) gets
> probed before the one at mmc@2140000 (for external SD cards). The 
> effect
> is that the eMMC controller gets the /dev/mmcblk0 name, and the SD card
> gets /dev/mmcblk1.

Thanks for taking care.

> Since the introduction of this SoC, that has never happened in 
> practice,
> even though it was never guaranteed in theory. Setting
> "root=/dev/mmcblk0p2" in /proc/cmdline has always caused the kernel to
> use the second partition from the SD card as the rootfs.
>
> Preserve that old behavior by adding some aliases which create naming
> consistency:
> - the SD card controller uses /dev/mmcblk0
> - the eMMC controller uses /dev/mmcblk1

Could you change this behaviour for the sl28 board(s)? I've always
found it counter-intuitive to have mmcblk1 being the eMMC on a board
which always have the eMMC populated. All our images uses UUIDs for
the "root=" parameter and, technically, the order wasn't specified yet.

So I'd like to have the eMMC as /dev/mmcblk0 and the SD card as
/dev/mmcblk1.

-michael