Re: [PATCH v1 1/1] scsi: ufs: Fix ufs power down/on specs violation

[Can Guo]

On 2020-12-09 15:09, Ziqi Chen wrote:
> As per specs, e.g, JESD220E chapter 7.2, while powering
> off/on the ufs device, RST_N signal and REF_CLK signal
> should be between VSS(Ground) and VCCQ/VCCQ2.
>
> Power down:
> 1. Assert RST_N low
> 2. Turn-off REF_CLK
> 3. Turn-off VCC
> 4. Turn-off VCCQ/VCCQ2.
> power on:
> 1. Turn-on VCC
> 2. Turn-on VCCQ/VCCQ2
> 3. Turn-On REF_CLK
> 4. Deassert RST_N high.
>
> Signed-off-by: Ziqi Chen <ziqichen@xxxxxxxxxxxxxx>
> ---
>  drivers/scsi/ufs/ufs-qcom.c | 14 ++++++++++----
>  drivers/scsi/ufs/ufshcd.c   | 19 +++++++++----------
>  drivers/scsi/ufs/ufshcd.h   |  4 ++--
>  3 files changed, 21 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
> index 1e434cc..5ed3a63d 100644
> --- a/drivers/scsi/ufs/ufs-qcom.c
> +++ b/drivers/scsi/ufs/ufs-qcom.c
> @@ -582,6 +582,9 @@ static int ufs_qcom_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  		ufs_qcom_disable_lane_clks(host);
>  		phy_power_off(phy);
>
> +		if (hba->vops && hba->vops->device_reset)
> +			hba->vops->device_reset(hba, false);
> +

Can you make a new wrapper func to do this? ufs-qcom.c is the vendor
driver, why call hba->vops->func() in vendor driver?

>  	} else if (!ufs_qcom_is_link_active(hba)) {
>  		ufs_qcom_disable_lane_clks(host);
>  	}
> @@ -1400,10 +1403,11 @@ static void ufs_qcom_dump_dbg_regs(struct 
> ufs_hba *hba)
>  /**
>   * ufs_qcom_device_reset() - toggle the (optional) device reset line
>   * @hba: per-adapter instance
> + * @toggle: need pulling up or not
>   *
>   * Toggles the (optional) reset line to reset the attached device.
>   */
> -static int ufs_qcom_device_reset(struct ufs_hba *hba)
> +static int ufs_qcom_device_reset(struct ufs_hba *hba, bool toggle)
>  {
>  	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
>
> @@ -1416,10 +1420,12 @@ static int ufs_qcom_device_reset(struct ufs_hba 
> *hba)
>  	 * be on the safe side.
>  	 */
>  	gpiod_set_value_cansleep(host->device_reset, 1);
> -	usleep_range(10, 15);
>
> -	gpiod_set_value_cansleep(host->device_reset, 0);
> -	usleep_range(10, 15);
> +	if (toggle) {
> +		usleep_range(10, 15);
> +		gpiod_set_value_cansleep(host->device_reset, 0);
> +		usleep_range(10, 15);
> +	}
>
>  	return 0;
>  }
> diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
> index 92d433d..5ab1c02 100644
> --- a/drivers/scsi/ufs/ufshcd.c
> +++ b/drivers/scsi/ufs/ufshcd.c
> @@ -8633,8 +8633,6 @@ static int ufshcd_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  	if (ret)
>  		goto set_dev_active;
>
> -	ufshcd_vreg_set_lpm(hba);
> -
>  disable_clks:
>  	/*
>  	 * Call vendor specific suspend callback. As these callbacks may 
> access
> @@ -8664,6 +8662,7 @@ static int ufshcd_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>
>  	/* Put the host controller in low power mode if possible */
>  	ufshcd_hba_vreg_set_lpm(hba);
> +	ufshcd_vreg_set_lpm(hba);
>  	goto out;
>
>  set_link_active:
> @@ -8729,18 +8728,18 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  	old_link_state = hba->uic_link_state;
>
>  	ufshcd_hba_vreg_set_hpm(hba);
> +	ret = ufshcd_vreg_set_hpm(hba);
> +	if (ret)
> +		goto out;
> +
>  	/* Make sure clocks are enabled before accessing controller */
>  	ret = ufshcd_setup_clocks(hba, true);
>  	if (ret)
> -		goto out;
> +		goto disable_vreg;
>
>  	/* enable the host irq as host controller would be active soon */
>  	ufshcd_enable_irq(hba);
>
> -	ret = ufshcd_vreg_set_hpm(hba);
> -	if (ret)
> -		goto disable_irq_and_vops_clks;
> -
>  	/*
>  	 * Call vendor specific resume callback. As these callbacks may 
> access
>  	 * vendor specific host controller register space call them when the
> @@ -8748,7 +8747,7 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  	 */
>  	ret = ufshcd_vops_resume(hba, pm_op);
>  	if (ret)
> -		goto disable_vreg;
> +		goto disable_irq_and_vops_clks;
>
>  	/* For DeepSleep, the only supported option is to have the link off 
> */
>  	WARN_ON(ufshcd_is_ufs_dev_deepsleep(hba) && 
> !ufshcd_is_link_off(hba));
> @@ -8815,8 +8814,6 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  	ufshcd_link_state_transition(hba, old_link_state, 0);
>  vendor_suspend:
>  	ufshcd_vops_suspend(hba, pm_op);
> -disable_vreg:
> -	ufshcd_vreg_set_lpm(hba);
>  disable_irq_and_vops_clks:
>  	ufshcd_disable_irq(hba);
>  	if (hba->clk_scaling.is_allowed)
> @@ -8827,6 +8824,8 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>  		trace_ufshcd_clk_gating(dev_name(hba->dev),
>  					hba->clk_gating.state);
>  	}
> +disable_vreg:
> +	ufshcd_vreg_set_lpm(hba);
>  out:
>  	hba->pm_op_in_progress = 0;
>  	if (ret)
> diff --git a/drivers/scsi/ufs/ufshcd.h b/drivers/scsi/ufs/ufshcd.h
> index 61344c4..47c7dab6 100644
> --- a/drivers/scsi/ufs/ufshcd.h
> +++ b/drivers/scsi/ufs/ufshcd.h
> @@ -323,7 +323,7 @@ struct ufs_hba_variant_ops {
>  	int     (*resume)(struct ufs_hba *, enum ufs_pm_op);
>  	void	(*dbg_register_dump)(struct ufs_hba *hba);
>  	int	(*phy_initialization)(struct ufs_hba *);
> -	int	(*device_reset)(struct ufs_hba *hba);
> +	int	(*device_reset)(struct ufs_hba *hba, bool);
>  	void	(*config_scaling_param)(struct ufs_hba *hba,
>  					struct devfreq_dev_profile *profile,
>  					void *data);
> @@ -1211,7 +1211,7 @@ static inline void
> ufshcd_vops_dbg_register_dump(struct ufs_hba *hba)
>  static inline void ufshcd_vops_device_reset(struct ufs_hba *hba)
>  {
>  	if (hba->vops && hba->vops->device_reset) {
> -		int err = hba->vops->device_reset(hba);
> +		int err = hba->vops->device_reset(hba, true);
>
>  		if (!err)
>  			ufshcd_set_ufs_dev_active(hba);