[PATCH v3 6/9] spi: tegra210-quad: Add support for hardware dummy cycles
From: Sowjanya Komatineni
Date: Fri Dec 11 2020 - 16:20:07 EST
Tegra Quad SPI controller hardware supports sending dummy cycles
after address bytes.
This patch adds this support.
Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
drivers/spi/spi-tegra210-quad.c | 22 +++++++++++++++++++++-
1 file changed, 21 insertions(+), 1 deletion(-)
diff --git a/drivers/spi/spi-tegra210-quad.c b/drivers/spi/spi-tegra210-quad.c
index 624f395..1d1b125 100644
--- a/drivers/spi/spi-tegra210-quad.c
+++ b/drivers/spi/spi-tegra210-quad.c
@@ -124,6 +124,13 @@
#define QSPI_DMA_TIMEOUT (msecs_to_jiffies(1000))
#define DEFAULT_QSPI_DMA_BUF_LEN (64 * 1024)
+enum transfer_phase {
+ CMD_BYTE_XFER = 0,
+ ADDR_BYTES_XFER,
+ DATA_BYTES_XFER,
+ MAX_XFERS,
+};
+
struct tegra_qspi_client_data {
int tx_clk_tap_delay;
int rx_clk_tap_delay;
@@ -857,6 +864,8 @@ static int tegra_qspi_start_transfer_one(struct spi_device *spi,
tqspi->command1_reg = command1;
+ tegra_qspi_writel(tqspi, QSPI_NUM_DUMMY_CYCLE(tqspi->dummy_cycles), QSPI_MISC_REG);
+
ret = tegra_qspi_flush_fifos(tqspi, false);
if (ret < 0)
return ret;
@@ -977,7 +986,7 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
struct spi_device *spi = msg->spi;
struct spi_transfer *xfer;
bool is_first_msg = true;
- int ret;
+ int ret, xfer_phase = 0;
msg->status = 0;
msg->actual_length = 0;
@@ -987,6 +996,15 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
list_for_each_entry(xfer, &msg->transfers, transfer_list) {
u32 cmd1;
+ /*
+ * Program dummy clock cycles in Tegra QSPI register only
+ * during address transfer phase.
+ */
+ if (xfer_phase == ADDR_BYTES_XFER)
+ tqspi->dummy_cycles = msg->dummy_cycles;
+ else
+ tqspi->dummy_cycles = 0;
+
reinit_completion(&tqspi->xfer_completion);
cmd1 = tegra_qspi_setup_transfer_one(spi, xfer, is_first_msg);
@@ -1018,6 +1036,7 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
}
msg->actual_length += xfer->len;
+ xfer_phase++;
complete_xfer:
if (ret < 0) {
@@ -1203,6 +1222,7 @@ static int tegra_qspi_probe(struct platform_device *pdev)
master->mode_bits = SPI_MODE_0 | SPI_MODE_3 | SPI_CS_HIGH |
SPI_TX_DUAL | SPI_RX_DUAL | SPI_TX_QUAD | SPI_RX_QUAD;
master->bits_per_word_mask = SPI_BPW_MASK(32) | SPI_BPW_MASK(16) | SPI_BPW_MASK(8);
+ master->flags = SPI_MASTER_USES_HW_DUMMY_CYCLES;
master->setup = tegra_qspi_setup;
master->cleanup = tegra_qspi_cleanup;
master->transfer_one_message = tegra_qspi_transfer_one_message;
--
2.7.4