[PATCH 5/6] regulator: pf8x00: remove nxp,ilim-ma property

[Adrien Grassein]

This property seems useless because we can use the
regulator-max-microamp generic property to do the same
and using generic code.

The only things it changes is the default value. The original
code was using "2100" (mA) as default, but I think we should
keep the value in the OTP memory as the default one. This value
is automatically loaded in the register by the chip.

Signed-off-by: Adrien Grassein <adrien.grassein@xxxxxxxxx>
---
 drivers/regulator/pf8x00-regulator.c | 89 +++++++++++++++-------------
 1 file changed, 48 insertions(+), 41 deletions(-)

diff --git a/drivers/regulator/pf8x00-regulator.c b/drivers/regulator/pf8x00-regulator.c
index 308c27fa6ea8..335aa77ef5fc 100644
--- a/drivers/regulator/pf8x00-regulator.c
+++ b/drivers/regulator/pf8x00-regulator.c
@@ -150,6 +150,11 @@ static const int pf8x00_ldo_voltages[] = {
 	3100000, 3150000, 3200000, 3300000, 3350000, 1650000, 1700000, 5000000,
 };
 
+/* Output: 2.1A to 4.5A */
+static const unsigned int pf8x00_sw_current_table[] = {
+	2100000, 2600000, 3000000, 4500000,
+};
+
 #define SWV(i)		(6250 * i + 400000)
 #define SWV_LINE(i)	SWV(i*8+0), SWV(i*8+1), SWV(i*8+2), SWV(i*8+3), \
 			SWV(i*8+4), SWV(i*8+5), SWV(i*8+6), SWV(i*8+7)
@@ -199,32 +204,6 @@ static struct pf8x00_regulator *desc_to_regulator(const struct regulator_desc *d
 	return container_of(desc, struct pf8x00_regulator, desc);
 }
 
-static void swxilim_select(const struct regulator_desc *desc, int ilim)
-{
-	struct pf8x00_regulator *data = desc_to_regulator(desc);
-	u8 ilim_sel;
-
-	switch (ilim) {
-	case 2100:
-		ilim_sel = SWXILIM_2100_MA;
-		break;
-	case 2600:
-		ilim_sel = SWXILIM_2600_MA;
-		break;
-	case 3000:
-		ilim_sel = SWXILIM_3000_MA;
-		break;
-	case 4500:
-		ilim_sel = SWXILIM_4500_MA;
-		break;
-	default:
-		ilim_sel = SWXILIM_2100_MA;
-		break;
-	}
-
-	data->ilim = ilim_sel;
-}
-
 static int pf8x00_of_parse_cb(struct device_node *np,
 			      const struct regulator_desc *desc,
 			      struct regulator_config *config)
@@ -235,13 +214,6 @@ static int pf8x00_of_parse_cb(struct device_node *np,
 	int val;
 	int ret;
 
-	ret = of_property_read_u32(np, "nxp,ilim-ma", &val);
-	if (ret)
-		dev_dbg(chip->dev, "unspecified ilim for BUCK%d, use 2100 mA\n",
-			desc->id - PF8X00_LDO4);
-
-	swxilim_select(desc, val);
-
 	ret = of_property_read_u32(np, "nxp,phase-shift", &val);
 	if (ret) {
 		dev_dbg(chip->dev,
@@ -272,7 +244,18 @@ static const struct regulator_ops pf8x00_ldo_ops = {
 	.get_voltage_sel = regulator_get_voltage_sel_regmap,
 };
 
-static const struct regulator_ops pf8x00_buck_ops = {
+static const struct regulator_ops pf8x00_buck1_6_ops = {
+	.enable = regulator_enable_regmap,
+	.disable = regulator_disable_regmap,
+	.is_enabled = regulator_is_enabled_regmap,
+	.list_voltage = regulator_list_voltage_table,
+	.set_voltage_sel = regulator_set_voltage_sel_regmap,
+	.get_voltage_sel = regulator_get_voltage_sel_regmap,
+	.get_current_limit = regulator_get_current_limit_regmap,
+	.set_current_limit = regulator_set_current_limit_regmap,
+};
+
+static const struct regulator_ops pf8x00_buck7_ops = {
 	.enable = regulator_enable_regmap,
 	.disable = regulator_disable_regmap,
 	.is_enabled = regulator_is_enabled_regmap,
@@ -319,14 +302,42 @@ static const struct regulator_ops pf8x00_vsnvs_ops = {
 			.of_match = _name,			\
 			.regulators_node = "regulators",	\
 			.of_parse_cb = pf8x00_of_parse_cb,	\
-			.n_voltages = ARRAY_SIZE(voltages),	\
-			.ops = &pf8x00_buck_ops,		\
+			.n_voltages = PF8XOO_SW1_6_VOLTAGE_NUM,	\
+			.ops = &pf8x00_buck1_6_ops,		\
 			.type = REGULATOR_VOLTAGE,		\
 			.id = PF8X00_BUCK ## _id,		\
 			.owner = THIS_MODULE,			\
 			.volt_table = voltages,			\
 			.vsel_reg = (base) + SW_RUN_VOLT,	\
 			.vsel_mask = 0xff,			\
+			.curr_table = pf8x00_sw_current_table, \
+			.n_current_limits = \
+				ARRAY_SIZE(pf8x00_sw_current_table), \
+			.csel_reg = (base) + SW_CONFIG2,	\
+			.csel_mask = PF8X00_SWXILIM_MASK,	\
+			.enable_reg = (base) + SW_MODE1,	\
+			.enable_val = 0x3,			\
+			.disable_val = 0x0,			\
+			.enable_mask = 0x3,			\
+			.enable_time = 500,			\
+		},						\
+	}
+
+#define PF8X00BUCK7(_name, base, voltages)			\
+	[PF8X00_BUCK7] = {				\
+		.desc = {					\
+			.name = _name,				\
+			.of_match = _name,			\
+			.regulators_node = "regulators",	\
+			.of_parse_cb = pf8x00_of_parse_cb,	\
+			.n_voltages = ARRAY_SIZE(voltages),	\
+			.ops = &pf8x00_buck7_ops,		\
+			.type = REGULATOR_VOLTAGE,		\
+			.id = PF8X00_BUCK7,		\
+			.owner = THIS_MODULE,			\
+			.volt_table = voltages,			\
+			.vsel_reg = (base) + SW_RUN_VOLT,	\
+			.vsel_mask = 0xff,			\
 			.enable_reg = (base) + SW_MODE1,	\
 			.enable_val = 0x3,			\
 			.disable_val = 0x0,			\
@@ -363,7 +374,7 @@ static struct pf8x00_regulator pf8x00_regulators_data[PF8X00_MAX_REGULATORS] = {
 	PF8X00BUCK(4, "buck4", PF8X00_SW_BASE(PF8X00_BUCK4), pf8x00_sw1_to_6_voltages),
 	PF8X00BUCK(5, "buck5", PF8X00_SW_BASE(PF8X00_BUCK5), pf8x00_sw1_to_6_voltages),
 	PF8X00BUCK(6, "buck6", PF8X00_SW_BASE(PF8X00_BUCK6), pf8x00_sw1_to_6_voltages),
-	PF8X00BUCK(7, "buck7", PF8X00_SW_BASE(PF8X00_BUCK7), pf8x00_sw7_voltages),
+	PF8X00BUCK7("buck7", PF8X00_SW_BASE(PF8X00_BUCK7), pf8x00_sw7_voltages),
 	PF8X00VSNVS("vsnvs", PF8X00_VSNVS_CONFIG1, pf8x00_vsnvs_voltages),
 };
 
@@ -458,10 +469,6 @@ static int pf8x00_i2c_probe(struct i2c_client *client)
 			regmap_update_bits(chip->regmap, reg,
 					   PF8X00_SWXPHASE_MASK,
 					   data->phase_shift);
-
-			regmap_update_bits(chip->regmap, reg,
-					   PF8X00_SWXILIM_MASK,
-					   data->ilim << PF8X00_SWXILIM_SHIFT);
 		}
 	}
 
-- 
2.20.1