[PATCH v2 3/4] spi: spi-geni-qcom: Don't try to set CS if an xfer is pending

From: Douglas Anderson
Date: Wed Dec 16 2020 - 17:44:04 EST


If we get a timeout sending then this happens:
* spi_transfer_wait() will get a timeout.
* We'll set the chip select
* We'll call handle_err() => handle_fifo_timeout().

Unfortunately that won't work so well on geni. If we got a timeout
transferring then it's likely that our interrupt handler is blocked,
but we need that same interrupt handler to adjust the chip select.
Trying to set the chip select doesn't crash us but ends up confusing
our state machine and leads to messages like:
Premature done. rx_rem = 32 bpw8

Let's just drop the chip select request in this case. Sure, we might
leave the chip select in the wrong state but it's likely it was going
to fail anyway and this avoids getting the driver even more confused
about what it's doing.

The SPI core in general assumes that setting chip select is a simple
operation that doesn't fail. Yet another reason to just reconfigure
the chip select line as GPIOs.

Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
---

Changes in v2:
- ("spi: spi-geni-qcom: Don't try to set CS if an xfer is pending") new for v2.

drivers/spi/spi-geni-qcom.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c
index d988463e606f..0e4fa52ac017 100644
--- a/drivers/spi/spi-geni-qcom.c
+++ b/drivers/spi/spi-geni-qcom.c
@@ -204,9 +204,14 @@ static void spi_geni_set_cs(struct spi_device *slv, bool set_flag)
goto exit;
}

- mas->cs_flag = set_flag;
-
spin_lock_irq(&mas->lock);
+ if (mas->cur_xfer) {
+ dev_err(mas->dev, "Can't set CS when prev xfter running\n");
+ spin_unlock_irq(&mas->lock);
+ goto exit;
+ }
+
+ mas->cs_flag = set_flag;
reinit_completion(&mas->cs_done);
if (set_flag)
geni_se_setup_m_cmd(se, SPI_CS_ASSERT, 0);
--
2.29.2.684.gfbc64c5ab5-goog