Re: [PATCH 12/13] cpufreq: qcom-hw: Implement CPRh aware OSM programming

[Viresh Kumar]

On 26-11-20, 19:45, AngeloGioacchino Del Regno wrote:
> On new SoCs (SDM845 onwards) the Operating State Manager (OSM) is
> being programmed in the bootloader and write-protected by the
> hypervisor, leaving to the OS read-only access to some of its
> registers (in order to read the Lookup Tables and also some
> status registers) and write access to the p-state register, for
> for the OS to request a specific performance state to trigger a
> DVFS switch on the CPU through the OSM hardware.
> 
> On old SoCs though (MSM8998, SDM630/660 and variants), the
> bootloader will *not* initialize the OSM (and the CPRh, as it
> is a requirement for it) before booting the OS, making any
> request to trigger a performance state change ineffective, as
> the hardware doesn't have any Lookup Table, nor is storing any
> parameter to trigger a DVFS switch. In this case, basically all
> of the OSM registers are *not* write protected for the OS, even
> though some are - but write access is granted through SCM calls.
> 
> This commit introduces support for OSM programming, which has to
> be done on these old SoCs that were distributed (almost?) always
> with a bootloader that does not do any CPRh nor OSM init before
> booting the kernel.
> In order to program the OSM on these SoCs, it is necessary to
> fullfill a "special" requirement: the Core Power Reduction
> Hardened (CPRh) hardware block must be initialized, as the OSM
> is "talking" to it in order to perform the Voltage part of DVFS;
> here, we are calling initialization of this through Linux generic
> power domains, specifically by requesting a genpd attach from the
> qcom-cpufreq-hw driver, which will give back voltages associated
> to each CPU frequency that has been declared in the OPPs, scaled
> and interpolated with the previous one, and will also give us
> parameters for the Array Power Mux (APM) and mem-acc, in order
> for this driver to be then able to generate the Lookup Tables
> that will be finally programmed to the OSM hardware.
> 
> After writing the parameters to the OSM and enabling it, all the
> programming work will never happen anymore until a OS reboot, so
> all of the allocations and "the rest" will be disposed-of: this
> is done mainly to leave the code that was referred only to the
> new SoCs intact, as to also emphasize on the fact that the OSM
> HW is, in the end, the exact same; apart some register offsets
> that are slightly different, the entire logic is the same.
> 
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxxx>
> ---
>  drivers/cpufreq/qcom-cpufreq-hw.c | 914 +++++++++++++++++++++++++++++-
>  1 file changed, 884 insertions(+), 30 deletions(-)

This is a lot of code, I need someone from Qcom's team to review it
and make sure it doesn't break anything for the existing platforms.

-- 
viresh