[PATCH] arm64: dts: imx8mq: Add clock parents for mipi dphy

[Guido Günther]

This makes sure the clock tree setup for the dphy is not dependent on
other components.

Without this change bringing up the display can fail like

  kernel: phy phy-30a00300.dphy.2: Invalid CM/CN/CO values: 165/217/1
  kernel: phy phy-30a00300.dphy.2: for hs_clk/ref_clk=451656000/593999998 ~ 165/217

if LCDIF doesn't set up that part of the clock tree first. This was
noticed when testing the Librem 5 devkit with defconfig. It doesn't
happen when modules are built in.

Signed-off-by: Guido Günther <agx@xxxxxxxxxxx>
---
 arch/arm64/boot/dts/freescale/imx8mq.dtsi | 11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
index a841a023e8e0..ca0847e8f13c 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
@@ -1016,9 +1016,14 @@ dphy: dphy@30a00300 {
 				reg = <0x30a00300 0x100>;
 				clocks = <&clk IMX8MQ_CLK_DSI_PHY_REF>;
 				clock-names = "phy_ref";
-				assigned-clocks = <&clk IMX8MQ_CLK_DSI_PHY_REF>;
-				assigned-clock-parents = <&clk IMX8MQ_VIDEO_PLL1_OUT>;
-				assigned-clock-rates = <24000000>;
+				assigned-clocks = <&clk IMX8MQ_VIDEO_PLL1_REF_SEL>,
+						  <&clk IMX8MQ_VIDEO_PLL1_BYPASS>,
+						  <&clk IMX8MQ_CLK_DSI_PHY_REF>,
+						  <&clk IMX8MQ_VIDEO_PLL1>;
+				assigned-clock-parents = <&clk IMX8MQ_CLK_25M>,
+						  <&clk IMX8MQ_VIDEO_PLL1>,
+						  <&clk IMX8MQ_VIDEO_PLL1_OUT>;
+				assigned-clock-rates = <0>, <0>, <24000000>;
 				#phy-cells = <0>;
 				power-domains = <&pgc_mipi>;
 				status = "disabled";
-- 
2.29.2