[PATCH 6/7] spi: cadence-quadspi: Wait at least 500 ms for direct reads

From: Pratyush Yadav
Date: Tue Dec 22 2020 - 13:46:19 EST


When performing a direct read via DMA the timeout for completion is set
equal to the read length. This is fine for larger reads. For a small
read like the Read Status Register command, the timeout would be 1 or 2
milliseconds. This is not enough to cover the overhead needed in setting
up DMA.

Make sure the timeout is at least 500 ms to allow DMA ample time to
finish. For reads larger than 500 bytes, the timeout will continue to be
equal to the read length.

Signed-off-by: Pratyush Yadav <p.yadav@xxxxxx>
---
drivers/spi/spi-cadence-quadspi.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index 1781d4e94ebd..90040664e1b9 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -963,7 +963,7 @@ static int cqspi_direct_read_execute(struct cqspi_flash_pdata *f_pdata,

dma_async_issue_pending(cqspi->rx_chan);
if (!wait_for_completion_timeout(&cqspi->rx_dma_complete,
- msecs_to_jiffies(len))) {
+ msecs_to_jiffies(max(len, 500UL)))) {
dmaengine_terminate_sync(cqspi->rx_chan);
dev_err(dev, "DMA wait_for_completion_timeout\n");
ret = -ETIMEDOUT;
--
2.28.0