Re: [PATCH 2/4] dt-bindings: net: Add bindings for Qualcomm QCA807x

[Andrew Lunn]

> +  gpio-controller: true
> +  "#gpio-cells":
> +    const: 2
> +
> +  qcom,single-led-1000:
> +    description: |
> +      If present, then dedicated 1000 Mbit will light up for 1000Base-T.
> +      This is a workround for boards with a single LED instead of two.
> +    type: boolean
> +
> +  qcom,single-led-100:
> +    description: |
> +      If present, then dedicated 1000 Mbit will light up for 100Base-TX.
> +      This is a workround for boards with a single LED instead of two.
> +    type: boolean
> +
> +  qcom,single-led-10:
> +    description: |
> +      If present, then dedicated 1000 Mbit will light up for 10Base-Te.
> +      This is a workround for boards with a single LED instead of two.
> +    type: boolean

Sorry, but no. Please look at the work being done for allow PHY LEDs
to be controlled via the LED subsystem. 

> +  qcom,tx-driver-strength:
> +    description: PSGMII/QSGMII TX driver strength control.
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    enum: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12]

Please use the actual values here, and have the driver convert to the
value poked into the register. So the property would be
qcom,tx-driver-strength-mv and it would have the value 220 for
example.

> +
> +  qcom,control-dac:
> +    description: Analog MDI driver amplitude and bias current.
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    enum: [0, 1, 2, 3, 4, 5, 6, 7]

Make here.

     Andrew